'32 Floor pans

The short answer is no. The 5W and the Roadster share the same floor which is essentially a flat floor. The Tudor floor by contrast has a flat section and a shaped deep stamped rear section. If you are building a hot rod and not concerned about authenticity than an aftermarket 5W/roadster floor could be fitted into a sedan body.
 
Last edited:
In addition to the good info provided by Tom, the front of the Tudor floor pan has two pieces of wood inserted as shown in the first attached photo. Instead, the front of the 5W floor has no wood but a section under the seat with two large depressions as shown in the second photo.
 

Attachments

  • IMG_1271.jpg
    IMG_1271.jpg
    61.1 KB · Views: 155
  • B-45 Front Pan - 6.jpg
    B-45 Front Pan - 6.jpg
    30.9 KB · Views: 152
Last edited:
Howard you should have asked me in Des Moines, I could have lifted the seat and showed you.
 
John R said:
In addition to the good info provided by Tom, the front of the Tudor floor pan has two pieces of wood inserted as shown in the first attached photo. Instead, the front of the 5W floor has no wood but a section under the seat with two large depressions as shown in the second photo.
Click to expand...
569644


569645
 
Most of the different (American) 32 bodies had different floors. Recognizing this was a mistake, I think most (America) 33s use the same floor.
 
I have both the trunk and under seat floor pans from United Pacific New In Box. Pick them up in San Fernando Valley cheaper than from UP or Speedway.
 
You must log in or register to reply here.
Back
Top