Charles Brock
Senior Member
Can anyone provide pictures of how the cloth welting is correctly installed on the #1 and #2 floorboards of a '32. In advance, Thanks So Much.
'32 #1 and #2 Floorboards
- Thread starter Charles Brock
- Start date
DavidG
Well-known member
I've no photos handy, but it is pretty straightforward. On the #2 board the black anti-squeak webbing is tacked to the edges of the two sides and back and then folded under and tacked along the undersides of those three edges.
On the #1 board it is tacked to the front edge in the same way and ends at the beginning of the recessed area where the sponge rubber weather seal for the pedals and steering column is located. A short piece of webbing is similarly tacked to the furthest outer edges that start at the bottom of the board. There is no webbing on the upper vertical sides, but rather felt strips are tacked there to serve as a weather seal up against the sides of the cowl. Roy Nacewicz has the felt strips for sale.
Originally, there was no webbing between the rear edge of the #1 board and the front edges of the #2 board.
On the #1 board it is tacked to the front edge in the same way and ends at the beginning of the recessed area where the sponge rubber weather seal for the pedals and steering column is located. A short piece of webbing is similarly tacked to the furthest outer edges that start at the bottom of the board. There is no webbing on the upper vertical sides, but rather felt strips are tacked there to serve as a weather seal up against the sides of the cowl. Roy Nacewicz has the felt strips for sale.
Originally, there was no webbing between the rear edge of the #1 board and the front edges of the #2 board.
Last edited:
Charles Brock
Senior Member
David, Thank you for all your help!!
jim1932
Well-known member
https://jrodda.smugmug.com/Cars/HenrysB/i-fmmqqW9
This should give you a good idea. look at photo 170 and up.
This should give you a good idea. look at photo 170 and up.
Charles Brock
Senior Member
Jim, Thank you so much