31 rdstr rumble fasteners

G

Garychinook

Member
Howdy,
Quit as an employee so consequently while not on the front burner the model a project is at least back on the stove! Just finished installing new floor panels
Two quick questions;
What fasteners are used on the outboard ends of the rumble curved inner panel if any? (3 @ each side?)
Same question for the rumble pivot bracket to body.
This unit was pretty much assembled with hardware store fasteners.
Thanks, Gary
 
the three fasteners for the panel is 1/4 20 x 5/8 stove bolts with lock washers and square nuts. the bolts for the rumble hinge brackets are 5/16 NF X 3/4 bolts with lock washers and one 1/4 20 X 5/8 stove bolt with lock washer that goes in the bottom of the drip rail.
 
You must log in or register to reply here.
Back
Top