29 cc pickup door garnish moldings???

[chero231]

FOUND THEM AT THE MODEL A STORE IN DENVER...THANKS !! MY 29 CLOSED CAB PICKUP IS MISSING THE GARNISH MOLDING THAT GOES AROUND THE THREE SIDES OF THE DOOR GLASS , I UNDERSTAND THIS IS A ONE PIECE THAT SLIDES OVER BRACKETS THAT MOUNT TO THE DOOR FRAME AND THEY ARE LEFT AND RIGHTS. I HOPE SOMEONE HAS THESE AVAILABLE OR EVEN PARTS ..THANKS, TED bowmant08@comcast.net

 

[wrndln]

I believe I noticed that on my 29 CCPU they are one piece. I am very sure the 3 parts, 2 sides and the top are one piece and screwed in place.

 

[SoCal_Alden]

Replaced my lever arm on the passenger side of my 29CCPU a couple of months ago (along with the felt window channels and rubber bottom stops.

Yes the molding you refer to is a one piece u-shaped affair thatslides onto two tracks.

The tracks are screwed onto the door frame and then the molding frame slide down.

I used a silicone grease on the tracks to help the sliding into place - took me a couple of trys to get it right.

I purchased the lever arm, felt channels and rubber bumpers from either Brattons or Snyders.

Best of Success to you!

Hope this helps.

 

[Dan Partain]

I saw one set in the fordbard classifieds for sale:

http://www.fordbarn.com/forum/showthread.php?t=24218

 

[Neil Wilson]

The door window trim is one piece and there is a right and left side. The slides for the trim are different for the hinge and lock side of the door.

Just a suggestion - It is best to not tighten slide slotted machine screws so that the slides have some movement to prevent trim binding when installing. When the trim is close to the bottom screws, then the bottom screws can be tightened. The upper screws can be a left a little loose.

The attached picture shows the trim and slide as it is being installed.