mjw
Senior Member
- City
- Wilkes-Barre
- State
- PA
- Price
- 800
28/29 doodlebug that I was going to make into a speedster. Was told it ran but I haven't tried to start it yet as it needs some wiring.
The frame is from a car and has been shortened 20inches and narrowed behind the cowl. The gas tank is good but the passenger side lower cowl needs some attention.
Tires hold air but the rear are worn to the cord. Brakes work.
The rear is from an AA and is welded to brackets bolted to the frame the trans looks to be also it has the reverse lockout.
The fab work is really nice, not your typical farm hack job.
I removed the carb (a Tilly) to clean it so it is not shown in the picts.
$800.00
More picts and hi res also upon request.
The frame is from a car and has been shortened 20inches and narrowed behind the cowl. The gas tank is good but the passenger side lower cowl needs some attention.
Tires hold air but the rear are worn to the cord. Brakes work.
The rear is from an AA and is welded to brackets bolted to the frame the trans looks to be also it has the reverse lockout.
The fab work is really nice, not your typical farm hack job.
I removed the carb (a Tilly) to clean it so it is not shown in the picts.
$800.00
More picts and hi res also upon request.
Attachments
Last edited:
