1942 Ford deluxe coupe project

Folks,
I helped John move the 42 from his garage to my place. We plan to install the fresh 59 AB engine and rebuilt transmission tomorrow.
Regards,
Chris
 
Ford folks,
John has many stories about this 42 Deluxe since he has owned it.
Here we are loading it for the short ride to my shop:
IMG-20220621-105655468-HDR-resized.jpg

Trip was uneventful and the 42 will get a fresh flathead today if all goes well. We did stop and vist with our friend Ron S who was the previous owner of the flathead engine. I think he liked the 42 also.
IMG-20220621-122432356-HDR-resized.jpg

Regards,
Chris
 
Folks,
IMG-20220622-103401573-resized.jpg

IMG-20220622-103709208-resized.jpg

IMG-20220622-104624855-resized.jpg

IMG-20220622-110714724-resized.jpg

IMG-20220622-110718083-resized.jpg

IMG-20220622-110734920-resized.jpg

The clam shell area was the hardest to get the fastners in place for sure. I would say not one of Fords better ideas. But it was my first time helping in that area.
Regards,
Chris
 
Folks,
Adding a little to John's thread for him. John's brother Tom stopped in to assist him on details inside the engine bay.
I believe these are some of the items tackled yesteday. Carb attached. Fuel pump installed. rods to choke and throttle and the foot throttle in place. A interference between the oil line and foot throttle linkage was resolved by Tom gently tweeking the steel oil line out tof the way. Front engine mounts were installed and a call was made to Michael Driskell to get a quick piece of information on the front mounts too.
IMG-20220623-112421598-resized.jpg

IMG-20220623-141435448-resized.jpg

IMG-20220623-141438749-resized.jpg

IMG-20220623-141443127-resized.jpg

IMG-20220623-141448592-resized.jpg

Regards,
Chris
 
I believe many of the later '42's had a mix of painted parts, some mild steel some stainless steel, but all painted. I think it depends what the assembly line had on hand at the time. I've seen some cars with mixed side trim all painted to comply with directives to reduce bright work on vehicles during the end of civilian wartime production.
A fellow here locally has a 42 "Black Out" coupe....ALL the bright work is black!!! I figure it was a "late" run car to have ALL the bright work black. He just passed about 8 months ago, not sure what's gonna happen with the coupe?
 
Rockfla, that would be a neat car to get pictures of! Again my car had both headlight rings painted. One was stainless underneath and one was stamped steel.
 
Rockfla, that would be a neat car to get pictures of! Again my car had both headlight rings painted. One was stainless underneath and one was stamped steel.
My Dad took a couple of pictures of it years ago, I have to see IF he can dig them out, the fellow also had a 33 5 window all original too!!!
 
Excellent photos. Is the '42 grille & '41 grille identical?

Is this an opera coupe w/ the opera-like fold-down seats? Is/was the business coupe quarter-windowless (previously termed three-window coupe) Thank you.
 
41 and 42 grilles are completely different. Front fenders are the same as a 1946. No rear seats, just a package tray (wood) and storage compartment behind the front seat. The 3 window coupes ended after 1936 to my knowledge. Ford called my car a "coupe" and the version with the longer door and rear seat a "sedan coupe" in 1942.
 
Thanks! '46= round parking lights; '47 =horizontal? or vic-versa . . . my parents had a typical (drk blue) tudor sedan md-'50s
 
Dale,
I believe that is a high temp paint on the exhaust manifolds. I thought they looks very good. With the way John his stuff organized and prepared the 42 coupe could be moving on its own in July this year!
I think he is going to mount the starter next and has his gas tank to come out for evaluation. Then we will move the 42 over here. We were considering towing it through town with one of the Allis tractors! Its about 2 miles from his place to the shop.
Regards,
Chris
On the Wis dairy farm (family established 80 acres in 1855) we had an Alice Chalmers 1937 WC that my father bought in 1957 reconditioned including the paint, to be used for field work.

What a monster for a 10-year old = deeep clutching . . . my left leg was too short unless I had death grips on the steering wheel, pulling my butt off the seat; Left & right brake levers were outta reach. A beast for me!

He also had the Ford Ferguson, bought new off the showroom floor in 1944; 'road gear' installed $100, plus dealer-supplied step plates( Henry did not include step plates, headlights, or rear plowing light.

Sooo much friendlier for me than the hold-on-for-your-life WC. (the Ford Ferg was used daily for 20 years w/one rebuild. (Harry Ferguson's idea= multiple hole drawbar. Harry & Henry unfortunately were not two peas in a pod. Harry said so-long after lawsuit(s).
 
Folks,
John made some additional moves on his 42 project. He tweeked the install of the new gas tank and has it ready for fuel.
IMG-20220626-112102670-resized.jpg

Regards,
Chris
 
Chris
I need to move up to PA near you and John....your determination and support of each other is great to see and wish I had the same here in North Florida!!! I could use and enjoy friends like you two!!
 
Bobby, Folks,
John does the work, I take the pictures! Seems to work out well! Just kidding, we help each other and its good to have a friend in the shop too. I am learning a lot about cars of the 40's too!

The radiator and its brackets, hardware, and hoses were installed by John today and it went pretty well! I assisted in a couple areas, and held some bolts from turning, provided my opinions and thoughts.

John tested his thermostats. They opened at about 180 deg F.
IMG-20220627-150946896-resized.jpg

IMG-20220627-153138722-HDR-resized.jpg

IMG-20220627-142125980-resized.jpg

I believe it is ready for water/ coolant.
Regards,
 
Folks,
A update on John's 42 Deluxe project. I really think he does better when I am not around!:)
IMG-20220628-184527154-resized.jpg

Looking real good in the engine bay! Details are coming together nicely. IMG-20220628-184535601-resized.jpg

I have been joking that he will probably drive it home. It sure looks like it could happen soon! I know he has some fluids to add, and I need to modify the battery hold down for him. Maybe some electrical items.like a new coil and the gen and fan mount. But I am impressed!

Regards,
Chris
 
Back
Top