1941 bed pieces

[47 flatbed]

City

Akron

State

Ohio

On the bed of my wife's 41 half ton there were welding cylinder rings cut out on top of bed edge. I'm looking for a section of the top of the sides. I need top from rolled top to the bottom of 45degreee bend 2 sections 15" long. Just pieces or one entire side. Hopefully someone has a bed where the top is solid
Thanks all

 

[47 flatbed]

Here are the sections I need.

 

[47 flatbed]

Anyone with these bed pieces? Called northern classic and no help on just pieces only whole side. Just need small sections or a whole side. Thanks again

 

[Stewart]

Hi: I have a couple of box sides from 1 ton. Not sure if the top rail is same as 1/2 ton. Please give me the width of the top angled piece and size of the rolled piece on top and the height of the piece of side wall. Asking $10.00 each plus shipping.
Stewart

 

[Stewart]

Hi: Was out today and measured the truck box side. Top roll is 1" outside and the sloped piece is 4-1/4" If that will fit your box I can cut the pieces out for you Stewart sdarr@mts.net

 

[47 flatbed]

Still looking for some help on these pieces.

Thanks
Mike