1940 Ford wheels?

M

mcgarrett

Well-known member
I have two 6.00 x 16" Ford wheels with dates of 11-18-40 and 11-19-40 stamped on the wheels. Would I be correct in assuming by the dates being so late in the year that they would be for use on 1941 Fords?
 
Production of 1940 Ford passenger cars was for pretty much ceased by October, 1940.
So yes, you'd be correct in assuming your rims would have been installed on a '41 Ford.
Other than the date codes, the rim design is the identical to 1940.
 
6" wide 1940 wheels? Are you sure? If they really are, they have to be rare commercial wheels, and are probably very valuable.
 
Kube said:
My guess? The original poster was measuring the very outside width.
Click to expand...

If not a typo, then agreed, we should school them, wheels are measured inside the flange. The wheel will be stamped with the size near the date stamp also.
Paul J.
 
Sorry, I just got excited. The wider steel wheels of the era are very coveted, and some with 1940 dates sounded like a real oddity.
 
487557

1940 Ford Deluxe 16 Inch Wheel
 
V8COOPMAN said:
Ain't that pretty? It just so happens that that particular wheel/tire is the original spare out of a '41, although it is the same wheel as a '40. Note the "FORD" script on tire at about one o'clock! Coop


.
Click to expand...



Note how the lugnut hole on the '40 and the '41 wheels have the normal
taper on the inside of each lugnut hole, but the '40 & '41 Wheels do NOT
volcano-out around each lug hole, as my picture of a '46 wheel below is,
but instead the '40 & '41 wheels are FLAT around each lugnut hole. ;)

Click on picture to Enlarge ;)
 

Attachments

  • 1946 Ford wheel lug hole.jpg
    1946 Ford wheel lug hole.jpg
    67.6 KB · Views: 263
Since we are discussing "original" 40 wheels, I think this is a good place to ask the expert about the changes in 41. The way I understood it was the 40 wheel was 4" wide, with the drop center having square sides on front and back. But in 41 they were 4" with a square drop on the front and a taper on the back. What say you Kube?
 
alchemy said:
The way I understood it was the 40 wheel was 4" wide, with the drop center having square sides on front and back. But in 41 they were 4" with a square drop on the front and a taper on the back.
Click to expand...


alchemy ....Do you actually have a 4-INCH wheel with drop center square in front, and tapered in rear? I have never seen a 16" (4" wide) Ford wheel like that. Coop

.
 
Tapered on one side are 4.5" wide I always thought. I had not ever noticed the different stamping around the stud holes though, so I have learned something new here
 
You must log in or register to reply here.
Back
Top