Okay, here's what I found. There are six rather elusive bolts in the back area of the body that must come out. In the furthest rear crossmember there are two in about the center of that crossmember that go up in the tail pan area. These two are about 6" to 8" apart where they bolt to that crossmember. Then there are two more in the far back that each come down from the trunk area through the brackets at the back corners of the frame that the rear bumper arm brackets bolt to. Those are probably the two most elusive bolts that I can remember. Then there are two more carriage head bolts on either side of a U shaped floor support bracket that is located just forward of the front of where the gas tank mounts, near where the front corners of the gas tank would have been. These are the long bolts that I remembered that go through holes in wooden blocks that are at either end of of that U shaped floor support bracket. This is a tudor sedan that I am looking at, so I am hoping the 5w coupe is the same in this area. Clear as mud?? I hope you can understand all of this. If not, I guess I could take some pictures of these areas and bolt holes tomorrow evening when I get home, but see if you can find these first on your own.
