1934 driveline install help

D

Duke

Senior Member
Trying to mock up my 34 to see how things fit. I bought it in pieces. I have the transmission attached to the torque tube, but it seems to be 1/4” too far to the back. Also, what is the trick to doing up the nuts on the bottom of the torque tube?
Thanks
 
I don't have the numbers handy but there was a different length torque tube for the 4 cylinder compared to the V8. I am not sure what nuts you are talking about on the bottom of the torque tube, how about a picture.

Charlie Stephens
 
Can’t seem to get the pictures to post here. The nuts that hold the torque tube to the trans. Mount.
Is there a install sequence? Is the 4 cylinder driveshaft longer?
 
Charlie Stephens said:
I don't have the numbers handy but there was a different length torque tube for the 4 cylinder compared to the V8. I am not sure what nuts you are talking about on the bottom of the torque tube, how about a picture.

Charlie Stephens
Click to expand...

The difference in torque tube lengths is 1-1/2" between V8 and 4 -cylinder. DD
 
Duke said:
Can’t seem to get the pictures to post here. The nuts that hold the torque tube to the trans. Mount.
Is there a install sequence? Is the 4 cylinder driveshaft longer?
Click to expand...

Photo posting issues are usually because the photo file is to large. Reduce the photo to the size limits. If you do not know how to do that I can post them for you, email them to me at jseery@ymail.com
 
Duke said:
Trying to mock up my 34 to see how things fit. I bought it in pieces. I have the transmission attached to the torque tube, but it seems to be 1/4” too far to the back. Also, what is the trick to doing up the nuts on the bottom of the torque tube?
Thanks
Click to expand...
Duke, just did that 2 weeks ago. Must have been a problem for me before, as I found self locking nuts (AN) on bottom and castle nuts on top. Also found my special tapered 11/16 socket to fit close to torque tube.
 
I think I figured it out. The bolt holding the rear spring pack together was too big so it was pushing everything forward.
 
Yes, glad you have it figured out. The 1/4" discrepancy you described would not be due to a mismatch of V8 and 4 Cyl parts. Fwiw the 4 cyl drive shaft and torque tubes are shorter than V8s. the 4 cyl engine in a 33/34 has to come back further than the v8, so the trans mount is reversible to sit the trans further rearward, consequently the torque tube is shorter.

The clamshell nuts should be a 5/8 af. Ford used a lot of these, 7/16 unf normally (these days, anyway) being 11/16. Save any 5/8 af 7/16 nuts you may find when dismantling any old Ford. In the clamshell situation that extra clearance is helpful.

Mart.
 
Duke said:
I think I figured it out. The bolt holding the rear spring pack together was too big so it was pushing everything forward.
Click to expand...




'33/'34 TORQUE TUBE LENGTH


V8 = 61-13/16"
4-cyl = 60-3/16"
-----------------------------------------------------

DRIVE SHAFTS '33/'34

V8 = 60-5/32"
4-cyl = 58-7/16"
 
You must log in or register to reply here.
Back
Top