Search results

With the battery being under the floorboard on my A and 31Plymouth, I connected the battery tender clamps to the starter post and ground as suggested somewhere. Does anyone else do this? Any problems with doing this?

Thanks, I will recheck everything.

Trying to adjust my new brakes. Front drivers side not adjusting . Took off brake rod. Noticeing some play in the brake adjusting arm from the 15 degrees Should there be and play( 5-10 degrees)in the brake adjusting arm after the 15 degree forward angle? Remedy if a problem

May bring this 30 31 commercial shell to Rhinebeck- Not AA $155

Reading the original post reminded me of an article in the AACA magazine. We all have to go sometime but those of us with antique or collectible cars should take some steps NOW! A few I remember from the article: Document - Fuel shutoffs - Electrical cutoffs--- Location of keys- Special...

Thanks for your detailed response.

If the weather ever changes. I would like to paint the top irons on my roadster(31)... Do i just remove the plated screws to do this?

Should the headlight switch on the steering wheel have a click when changing to high-low or off or is it just a slide into the new position? ( New harness from Brattons)

Bought some baby power at the dollar store.

I read somewhere that Ford called it rustless steel in there advertising because they got their shells etc. from different suppliers and one had a copyright or patent on "stainless steel" so they didn't call it "stainless steel" true????

I just got my rear backing plates off without removing the radius rods. My problem now is getting the service brake springs off. Any suggestions on getting rear service brake springs off.

thanks I will check all of these.

Working on disassembly of rear brakes. (31 Roadster). Removed backing plate bolts. E-brake plate will not come off. What is holding it on?

Question on the fuse holders- If the fuse blows, does it affect all of the electrical or just lighting? Does it affect spark and coil function?

New wiring harness--- 6 volt - non signal light- tail lights on with low beam and high beam No tail lights with cowl lights Should tail lights be on with cowl lights ? Possible reasons no tail lights with cowl lights. Thanks

Jim replied to an earlier post on my socket question. 2 on left 30 31 . Longer one on right 28-29

I have been told I could have and engine that had been modified back in the 60's. I'm told it has a pressurized oil system. but the interesting thing is it has a B head on it. ( four stud water pump). I don't know if I want to mess with the engine assembly or if the head is worth anything...

If you are replying to my question about the cowl light connector ,maybe my wording was a little confusing. This is the connector I was referring to. currently there are 2 wires from the cowl lights screwed down into the brass connector .. A bullet connector from the main wiring harness will...

Maybe someone can answer my wiring question while we are on cowl light wiring subject I have a new wiring harness with a bullet end for the cowl lights The cowl light connector has a brass(?) piece with the 2 cowl light wires screwed down into it. Do I cut the bullet end and screw...

Thanks for your quick replies.