Search results

Found an old thread where rotorwrench explained it Pulled the field wire from the generator touched the field with battery power Generator works as advertised Thank you

That’s the question which type system do I have

I’m working on a 1948 F1 Pickup with a V8 Someone had previously switched the battery polarity to neg grid. I have switched it back to pos grd, verified the coil is pos grd. when it runs the amp meter moves to discharge I would like to polarize the generator but not sure what procedure to...

I agree, ticking could be a bad plug

Looking for complete power steering system for a 52 Mercury or partial Dave

1936 Rear End, complete with drums Very nice, no pits

It won’t start unless you have a magneto

The mirror you’re looking at from speedway looks like what is on my 29 roadster prolly made by vintique mine look and work quite well

Re: Preserving ‘patina’ WD40 will enhance the rusting condition You need to apply something that will stop the rust and keep it as is. Possibly rubbing LPS3 into the rusted areas will stop the rust and not give you a plastic coating look like any clear will.

I have read that first gen Mustang seats fit nicely

Edsel Ford was the driving force behind the model A I also read the other day that was also placed in charge of the Lincoln line after Henry purchased Lincoln Maybe the Lincoln was his inspiration for the model A

Ken, it does look very good Will be too nice to drive

Ken, you should purchase a 57 carb and intake that is still attached to the 57 Tbird

Possibly the roll pin is sheared in the handle

It appears that the pin, chrome piece simply needs to be placed onto the stud and held on by the set screw I don’t see anything broken

Maybe the stud could be welded back to the base The pin hold the seat back to the base

Pictures help

Yes the stud holds the seat back to the base one on either side Held with a cotter (split) pin

It’s amazing that it took 60 before someone figured out that the Tbird had no coolant flow at idle. Thank you Mr Chris Ames

Best to start by a thorough cleaning to identify the source of the leak Dye check developer can be used to find the leak at early stages The leak location should be identified before removal