Search results

Don't use any armor-all type products on the tires this will cause them to yellow as well

If you live in Va. they charge a $100 fee a year if you own a Hybrid Car! Governor this is for the fuel tax that we save and the state looses because they get better gas mileage.

Try a marine supply store ?

any good paint supply store will have MEK

How about the use of a product called CLR can this be used to clean remove the scale from a Radiator

this is a pot metal carb

What cleaning material can I use to clean the exterior of a carb. the carb iis unpainted and has been flooded many times it looks like I used the spray can type carb cleaner and it still looks the same

Not sure why the orginial drums were swedged, newer cars have brake drums that slide on over the studs and I have never seen a problem, I conclude the stud holes must be oversized to require this?

Thanks

I have installed electronic ingition on my a, I have a scope that came out of a 70's garage put was told it would not work with electronic ingition, the manual I have with the scope does not address electronic ingition, question is can it be used and will it harm the scope if hooked up to it?

very simular to the quick lift that went out of business I have one and like it

where do you by a sway-bar for a model a

does the car need to be rewired with the f-100 box or can the stock switch be used?

Yes, I think it is easier to put in bore of hub and slide hub on axle then torque

connect to connection box on firewall only one side is hot with switch off ,otherside is hot 24 /7 chect with meter to make sure you get the right post

this is a drive on type raise back end with floor jack about 20" off ground when raised

found a good price for a kwik lift need to disassemble and move to my garage. Not knowing much about them can one old dude disassemble and load in a pick-up truck about how heave is the larges pice and how long to disassemble.

I checked the carb on my car it runs fine put don"t know who built it it has a X on the side of it this is the only thing i could see with out pulling does any one know who build it in case I need parts in the futher

removed old trim by sliding with help from end would think install would be reverse the running board would have to be stright than install screws from back

I would purchase also online if availble