Search results

need oversize timing gear +.003 alum. thanks, steve

What should I set my valve clearance at. I have a B cam, adjustable lifters, stock valves, and police head, bored .0100 , over. thanks for the help, steve

Does anyone know,can a model a windage tray be used in a model b oil pan, in a model B engine with a counter balanced crank?? steve, thanks

can a model a splash pan be used in a model b oil pan, in a model B engine with a counter balanced crank?

what I am trying to do is put a model a windage tray in a model b engine. I do not have the correct model b windage tray. I do have the correct oil pan and shield.I had a model b engine with a model a early 28-29 pan on it.It does not have the counter balance crank. This was a running engine. steve

In another post we talked about model B oil inter splash pan., some has holes some did not. My question is can any tray be used on a model B engine? Does it have to be the lower tray ? steve

THANK YOU ..THAT IS IT .. steve

need pictures of the edge, long side of the splash pan , so as to see the difference.steve

need pictures of the side of the oil splash pan,where the bumps that go into the pan are. B is suppose to be lower sitting in the pan. need to see the difference by comparison side to side. thanks steve in tampa

I need pictures of the side of the dipper tray to see the difference in the bulges. steve

Can anyone post pictures of the oil splash pan of the model A and the B. The B inter splash pan is suppose to sit lower in the oil pan . I would to like to see pictures of the side of both to tell the difference. Thanks, steve

I do not want to take my gas tank out to clean it. I want to fill it with vinegar . I do not know how long to let it soak, any ideas ? Has anybody done this, how much mess does this make on top of the tank ? thanks, steve

....... WANTED ...... K.R. Wilson engine lift ] The tool that attaches to the Model A head to pick up a engine. Has three holes for different angles, depending on w/ or w/out trans. attached. steveankc@gmail.com

.o30 pistons nos , no info

clearance between piston and cylinder wall on a new bore steve

when you bore a new cylinder, what should the clearance be for the piston? Thanks, steve

where can yo buy reconditioned B rods. thanks, steve

What thread size is the dist shaft,where the cam attaches? thanks, steve

out of tow and will not be back for a few days , so no pics.so any a pan will work, just hammer out the side or use jam nuts ? steve

have a model B motor with a 28-29 A oil pan on it on a model A chassis. (Just bought it) I did not think that a ford a oil pan would fit . Anybody got any info on this. steve