Search results

i also have same water pump in my 31 deluxe delivery has a bearing each end got it club flea market cant find any info would like to know who made it

hi looking for new rear 10 leaf for 130 b willstop by

cant get a hold of them phone not in service been at hershey for years are they still in business in ct

tried to phone number not in service any one heard if still in business they always at hershey thanks dave

the 46 has fan noise with belt off has a litle movement on fan shaft any after market parts avaible still has oil in hub any help would be apreciated dave

the shake is releasing the pressure plate after that works perfict no vibration at all flywheel balanced new pressure plate and disk

cant get vibration out from standard clutch on a non balenced engine pressure plate macs says 7 lbs off flywheel i have a lightined flywheel on other A has h/h touring engine they left a ridge on flywheel face presure plate fits inside ridge any help on how mutch to take off for non balenced and...

Bubba was in hospital talked to has wife yesterday out now but has put all work has been on hold

try tighting water pump nut on the shaft as it will suck air on a hard pull it cured my same problem

changed motor from 8 ba to 59 a thought risister reduced voltage to coil but i get 6 vt both sides of risister green bible says .51 max ohms thats what my meter reads set at 1 k am i good to go with that any info is apreciated thanks

thanks ill today check that today

appears dif oil gets on speedo gear on drive shaft cable brings to dash then runs down valley under dash to floor where your foot is on gas peddel just starting to drive 31 deluxe delivery going to try new oil mybe have to light oil by previous owner any one have this problem thanks

i have 3.25 in 46 convertible stock 8 ba runs great no problems with hills lots of model A'S running 327 in stock engins that work well here

hi mark have 2 a heads look ok south of ottawa

my 31 delivery has a small brass plate on the cowl the face is badly worn i think with a magnifying glass the name Y HENESEY and series of numbers below the name i thought murray or briggs were the body mfg . could this be another i just just finished getting ready for the road will try to post...

i just replaced the brake light switch on my 46 to my suprise napa has 2 grads in stock went for the top grade 8.$works well im on silicone fluide

my 46 ford conv. the front axle width at backing plats is aproxamatly 1in narrower than the the rear meaured at backing plates same results measuring width outside to outside of tires may wrong axle be the culprit after 50 mph car doen;t handle well the whole front end every part rebuilt and...

i know briggs and murrey four doors who made roadster coupe 2 door coach and pickups thanks dave

thanks everyone its great to know help is only a click away once i get it home in april ill post some pictures thanks again

thanks for the info as far as numbers remaining i only know of 3 yours amir in montreal and i just got one my self i hope the rear corner bracket you copied at hershey worked out. once i get mine home the fun will start i my need some more info thanks dave