Search results

That's the one Bob.

JSeery - Thanks for checking. Not that type though. I think Bob C's link is the ticket. I emailed the vendor. Thanks!

In search of 6 volt replacement bulbs for the fog lamps on my 1941 Ford Super Deluxe. Can't seem to find them online. Part number might be 1007. Any advice is appreciated!

Hello all, This is for a 1941 Ford Super Deluxe with a single Holley 94. What are the best options for replacing the stock oil bath filter with a paper element filter. This is intended to be a reliable driver and not a show car. Thanks in advance!

Thanks guys! A couple of good options and the pics are appreciated!

I bought a mounting bracket for the coil from Mac's. Any suggestions as to the best place to mount it? http://www.macsautoparts.com/ford_mercury_early/coil-mounting-bracket-chrome-for-a12000-or-b6a-12029-b-coils-ford.html

It's a 1941 Super Deluxe but it had already had an engine swap when I bought it. It has a 59AB from a truck. The crab was probably correct for the engine if not the car. I'm keeping the helmet and will likely have it rebuilt.

Thanks!

The resistor to be bypassed is between the ignition switch and the coil correct? Is it under the dash? Thanks again!

Thanks Charlie!

I forgot to mention, I am using points based on the recommendations of others on the forum and I purchased a rebuilt crab.

I forgot to mention, I am using points based on the recommendations of others on the forum.

I am converting to a crab distributor from a helmet. The system is 6 volt positive ground. I have a Pertronix Flamethrower coil. Question is, how do I wire the external coil? Where do I make the connections? Thanks in advance!

I am heeding the advice of the sages. I purchased a rebuilt crab distributor and will keep the points. This is a 6 volt positive ground system. What is the best coil for this? What is the correct connection for the coil terminals? Thanks again wise ones!

Will I need to do anything to adapt a crab distributor to the 59 AB given that it currently has a helmet distributor installed?

I am hoping to DIY this.

I have a 59 AB in a 1941 Ford Super Deluxe. The distributor is the helmet style. I want to convert to an electronic ignition in a crab style distributor. I want to keep the 6 volt system. Any advice as to what is involved would be greatly appreciated!

Big thanks!

Hello all, I installed new water pumps and I am installing a new Walker radiator. The old mounts were kind of a mishmash of rubber, bolts and nuts. I ordered a kit from Macs. Each side contained a square rubber with a hole in the center, two springs, a bolt, a castle nut, and cotter pin. No...

Finally got around to installing the pumps. All is well. I am also installing a radiator and have the mounting hardware but not quite sure how it works as the old mounts were a mixture of odd parts. For each side I have a rubber pad, a bolt, a nut, a cotter pin and two springs. No instructions...