Search results

i tried it hueyhoolihans way seems to work. 1 can't see why this wouldn't last thanks a lot

Thanks I think I get it. Do you pull the spring tight so part of the spring is on the lever and part of the spring is in the tube no more of the spring can go in the lever with the clip installed

on the rear cable there is a small clip that goes some where on the cable part number 91a 2113 where does it go thanks

Other than the brake shoe cam holes round or 2 straight sides is there any difference in the shoes. my 47 has the round holes but catologs call for the straight holes thanks

Also on the body where the door shuts there is 2 metal plugs where the rear windows are attached. Remove the plugs and you loosen the 2 bolts there and you can move the window up or down. I believe the bolts are allan heads. Bill

same problem. I've ajusted them a hundred times. The bind on the windows is hard on the regulator gear. I just unlatch the roof and they work. i do not have to put the roof down. i've talked to other owners and some have the same problem. The problem is likely the rubber is slightly to big or...

Hi i can not get rear brake drums over the shoes. Drums cut .020 new drums new wheel cylinders emey brake not hooked up. I can get the drum on about half way. i've been told the shoes may be oversized and have to be cut down. That seems to be something done in the past. Can you by shoes that...

can a 1950 ford f 100 side shift open drive transmission fit a 1948 car. I know i must convert to open drive Thanks

What year did fordvf 100 go to column shift

What year did ford f 100 go to a column shift

What year did ford f 100 go to the column shift Thanks

Can a 1947 transmission be changed to open drive

If both of the pins are broken will the car still drive.. What kind of noise or vibration would you get with broken pins

Sorry 1947 ford coupe

Is a difference in size between a 4 door and a sedan coupe

Thanks

Has anybody run in to fit problems with the metal scuff plates in a 1940 ford coupe from carpenter.

The sheet metal that goes above and below the rad is all different. The 6 cly. rad mounts way ahead of where the v8 rad sits.

Had bad chatter in my 47 ford.in 1st and reverse. If i road the the clutch a little i had no chatter. Replaced all the mounts,fort wayne clutch and machined the flywheel. I also installed new bearings in the rear end only because the rear was out and needed some seals. Only real problem i...

Had the same problem with I liner I installed years ago. The rad shop at the time only seen it a couple of times. It was due to ethanol. The newer sealers are ok