Search results

Thanks. Let me know of any insight. Have to do this to my 47 Merc.

I have 47 Merc convert. Can you send pictures? How old and condition? don@rbmfg. com

What is a fender fill panel?

Hi, Don in Bolingbrook. I'm looking for the center plastic speakergrill bezel between the clock and spedo. You wouldn't happen to have one?

Wow that was easy. THANKS GUYS! I knew the answer was not to put in a droping resistor. This could probably work for a certain gage but why take all the electric engery that you burned gas to make and convert it back to heat. Another challange: To generate and store electricity why not...

I converted the start and run part of my 47 Mercury convertible to 12VDC. Starter runs much faster and draws less current and I can use an off the shelf battery. But now for keeping the original 6V instruments. Probably can't run all off of a dropping resistor as varying resistance of all...

Hope Carlisle was great. Sent you via email a list for pricing. Don

Chuck, I will take two if you still have any left. I assume they are interchangeable for either side. I have a 47 MERC CONVERTIBLE. Send me your address a will send ck or paypal don (at) rbmfg (dot) com will reach me Don

Sorry, I must have missed this but I am definately interested in a few items if they are available. Don

Good luck at Carlisle. Talk to you when you return. Don

Hi Ryan. I'm also looking for both rear on a 47 Merc. Did you have any luch?

Looking for 47Merc parts. Dash instrument cluster, clock, spedo, outside chrome & pop metal. Don

There has to be thousands of great metal formers out their. There has to be over a thousand 40 Fords that have been repaired or restored over the decades! Some one has made a lower rear door post form or has a template for forming this part. Any one there with any ideas? Last resort is...

Thanks oldskool, They all have rocker panels but no one seems to have the rear lower back door post or inner fender skirt patch panels. Tried Bob Drake, EMS and macsautoparts. Don

Hi, Im restoring a 1947 Merc convert. Interested in some of your parts and we are somewhat close. I will contact your on your private link. Don

Restoring a 1947 Mercury Convertibles. Everyone says the metal from the cowl back is same as Ford. Here is my questions: 1.) Does anyone make a lower rear door post patch Panels? 2.) Do I have to custom make the top quarter inner skirt (inner fender). My outer fenders are good. Just...

Thanks everone, some good advise. My metal is pretty solid except for problem areas. Hey after 66 years.... One other area I have to solve is the left rear drivers hinge post. Mine is pretty bad about the bottom 3 inches. 1.) Does anyone make a patch panel for this? 2.) Also does anyone...

I am about to do the same project. So lets stay in touch. Here is what I am planning. 1. Clean metal is key, so im cutting out the old and sand blasting and grinding the lip on the floor where the top of the inter rocker is factory tack welded. 2. My car is a 1947 Mercury convertable...

Sam, On your parking lights. Could you send me a picture to make sure that these would fit my 47 Mercury convertable. What condition is the polished bezel ring in? You can email me at don@rbmfg.com Don

Yup, you is correct. Im learning.... tks. Don still looking for a lot of 1946-1948 Mercury parts plus some patch panels. If anyone has any leads, give me a yell. Don