Search results

I got the pump out of the car. The bushing turns with the packing nut. In a pinch as my daughter gets married first of September using the car, so I think I will just order a new pump and rebuild this one later. Thanks.

I am trying to remove the packing nut from the water pump. I have a pump wrench and have been turning it CCW for some time now and I cannot see that it is coming off. Are the threads internal? Could it be loose but stuck on the shaft? The shaft does not turn with the nut. And ideas...

bttt

Bill Williamson, where can I buy one of these Petcock valves? I agree most fuel valves you get from the vendors leak thru after a few days.

I bought a rebuild kit and went to rebuild one of my old tank valves. I found something I was not expecting. A spring loaded o-ring. Never seen one like this, It has no packing. Anybody seen one like this before?

Its allowing the fuel down the line.

Seems like I have to replace my gas tank valve about every two years. My current one is two years plus and has started weeping again. I bought this one from Snyders. Who is making a good under tank valve and is there any new improved ones out there?

I run a model b carb. I tried the gross jet valve, it kept cutting off the gas, no matter what adjustments i made. I am using a old steel pin type i got out of a old model b. It will drip some when i shut the car off and my gas tank valve is good. I keep hoping someone will make a better valve...

I have been having problems with Direct Replacement Halogen Headlight Bulbs. I had a bulb go bad, I bought a new one from one of the A vendors and it was dim. It only burns one element. When I try my old bulb from the other headlight of the car in the same socket it works fine. The only...

I have been running a model B carb on my A since I got it in 2007. I have rebuilt it several times, but it has a chronic problem I have always just lived with. After turning the car and gas valve off, the carb starts to drip. I have tested the gas valve, it is fine. It does not leak. I...

Anybody going to the Charlotte Autofair next week?

Thanks to all our vets out there. I know a lot of you frequent the Ford Barn. My dad was a WW2 and Korea CPO Navy vet. He is gone now. Thank you all for your service.

#1 rule. Make sure the car is out of gear, Our your arms will not be your only problem.

Does the amp meter move at all when you turn the key switch on? The key switch may be bad, The car will turn over even if the key switch circuit is not closed. But the car will not start because the key circuit is not closed. If the amp meter does not move a little when the key is turned, then...

Definitely homemade.

I store it in my garage. It's insulated. But it's been cool here lately at night.

I would remove the helicol and retap the original thread as best as you can. Get a tangless threaded insert not a helicol. McMaster-Carr.com is a good source. You will have to go smaller on the bolt though. The outer thread will match the size of the original hole. The inner thread will be a new...

I went to start up the A on Sunday and noticed the starter did not work when I put my foot on the button. Heard some frying and smelled smoke. Opened the hood and saw sparks and smoke. The starter switch was red hot. Lucky I have a power cutoff switch right beside the starter. I could see the...

Mikes A-ford-able. If he has them in stock still. He gets them from a small shop and it takes awhile to restock. He had them about three weeks back. Around $80.

I have a friend with at 30 Tudor sedan and we are going to add cowl lights to it. Does anyone out there have a diagram or drawing for the location? Seems like I remember seeing one on the barn in the past. Thanks in advance for the help.