Search results

  1. O

    pump

    On my 1956 Mercury Convertible I have arm strong steering & the belt is tight the power steering fliud is full any suggestions weather it is a malfunction of the pump or control valve or the ram??or other? Thank you in advance for input. Old Gas
  2. O

    Alternator

    Can anyone shed light on where I can purchase an alternator bracket kit for my 292 Y-block engine & what alternator to use. Thank you for your time in advance Oldgas:
  3. O

    steady rest

    Did Ford discontinue the front steady rest on the 1956 Ford Fairlane line-up late in the year of 1956? If Ford did this can i assume the steady rest is not essential at a motor mount & would be safe to not install it? Thank you for your time in advance. Old Gas
  4. O

    slinger

    Thank you for the contact information & your time. Cheers Oldgas
  5. O

    slinger

    I'm working on a y-block 292
  6. O

    6 volt. Starter installed in 56 ford car

    The 6 volt will spin faster ( no Worries)
  7. O

    slinger

    Can you tell me how essential or important the oil slinger on the crankshaft I am understanding it keeps the oil away from the crank seal. Would I be correct in saying that? The slinger was missed on a re-build. Thank you in advance for your input. Oldgas.
  8. O

    Fuel

    Thank you for sending the information on the sending unit. Much appreciated. Oldgas
  9. O

    Fuel

    I have purchased a fuel sending unit from Dennis Carpenter for my 1956 Ford Sunliner .Part No. .B6A-9275 Could anyone tell me the Ohm readings on full & on empty. Carpenter also indicates that this unit only is compatible with an original gauge which my gauge is original. Thank you in advance...
  10. O

    speedo gear

    I have installed a T10 re-built from a 64 Ford Galaxy four speed transmission in my 56 Ford Sunliner and wondering what speedo gear will work? Thank you in advance for any advise. Old Gas.
  11. O

    Lifters

    Thank you Gentleman for the lifter information I will touch base with the contacts you supplied. Cheers Oldgas
  12. O

    Lifters

    Looking for a good supplier for a set of 16 lifters for my 292 Y-Block Thank you in advance. Oldgas.
  13. O

    power steering pump

    Looking for the torque specs on the large 1inch bolt which holds the oil reservoir canister to the power steering pump housing on my 1956 Ford Fairlane. I have looked in the 1956 manual but no luck. Thank you for your time. Oldgas.
  14. O

    idler arm

    Thank you Sir: For your response to my question on the Torx spec's on the greaseable idler arm for my 1956 Ford Sunliner. But would you have a picture of the greaseable washer's & spacers for assembly or know were I can obtain a assembly picture? Thank you for your time. Oldgas ( Ron)
  15. O

    idler arm

    Looking for the Torx specs on a greaseable 1956 Ford Fairlane Convertible Idler arm. Thank you for your time. Oldgas
  16. O

    Drainage

    I have solved were the drain plugs are locates & which one goes were. Thank you for your time. Oldgas
  17. O

    Drainage

    I'm working on a 1956 Ford Sunliner. Thank You. oldgas
  18. O

    Drainage

    Work on a 1956 Ford Sunliner
  19. O

    Drainage

    I have installed new inner rear Quarter trunk drop-offs, There is two rubber plugs to be installed in the drop-offs one is a vent & the other is a plug & the location to my understanding is at the front & rear of the drop-off question which on goes were? Thank you for your time. oldgas
  20. O

    Garnish

    Wanted the R/H A pillar interior garnish molding for a 1956 Ford Convertible also a 1955 Ford Conv or a 1955/56 Mercury Convertible mold will also work. thank you for your time. Old Gas ( Ron)
Back
Top