Search results

car is sold

Recent body off rebuild , Everything on this 20+ year rebuild was taken apart, rebuilt or replaced. I used nos or USA parts when available. Rebuilt completely stock - suspension , etc. Powered by a professionally rebuilt 49 8ba flathead.hersh09@verizon.net

I read somewhere about using right stuff - does that work?

I am back for some advice on installing Vintique covers on my original reworked and repaired running boards. I have test fit covers and they seem to fit pretty good. My first question about making a smooth surface is , what about the little holes in the original surface? They will get covered up...

thanks , best pictures I have seen -

Thanks , looks like double seal on back of door - seems to have a piece going down body and on back of door? Is the piece on the front of the door below the top hinge on the door? thanks again.These were the clearest pictures that I saw.

thanks

I have been going through articles on door seals, but not really 41 coupe. I have the seals and my understanding is that the top seal goes on the body and the hinge seal goes on the door. I have the lower seal in the channel across the bottom of the door on the floor. I guess the little seal...

Took the failed cylinder apart and cleaned everything and put it back together - added fluid and bled brakes - so far so good - did not drive yet but at least got through bleeding and all that pumping - had a few fittings to tighten - will let go over night and see where we are at - On a...

Thanks for thoughts on this issue - I will be working on this soon and will see if I see why it happened.

The 41 coupe rebuild is proceeding and I am getting the details done for it to move around on its own. I have been working on this car for a while and have done a body off rebuild. I completely replaced and rebuild all suspension and brake parts - stainless brake lines, new master and wheel...

got pulley running almost perfectly straight , thanks for suggestions and info.

checked snout runout about 1/4" in from end and get about .0020. This engine was just built about a year ago with no road miles. I know the builder went "over" the crank. I trust that he thought it was ok or he would have told me. He treated me very good and informed me about things that he...

How much runout on the crank snout is ok?

After further review and removing the fan and pulley, the pulley is slightly skewed on the hub, but I also now have found that there is runout on the crank. I never noticed that before and I didn't indicate it yet but with the engine running I lay my finger on the front of the shaft and I can...

I should have checked trueness before final welding - It is possible I got carried away with my welding and warped it - Going to take it apart and start over - the only good thing I did was buy a second pulley assy. in case I have issues taking the pulley off, the original spot welds were...

I should have tacked it and tried it to begin with, but when I put the pulley on it seemed really straight - I guess what your saying is what has to be done, thanks.

Just installed a modified crank mount fan pulley on my 8ba in my 41 coupe. Got suggestions on this forum that got me to this point concerning the mods to get this done. Everything is lined up with pulleys but when I ran the engine the pulley (that was removed and turned around and rewelded) does...

Working on piecing things together, Have a piece of copper with elbow and was looking at that possibility. Also found an old hose from something else that has some 90 degree bends. Trying to cut and see if that could work. Thanks for suggestions

Got the 41 crank mounted fan pulley modified and mounted with the belt on the 8ba. Stock 41 radiator mounted in stock location. Now trying to figure out hoses for top and bottom. Top of radiator is reduced for smaller hoses, bottom is stock size. Got combination chrome pipe and rubber adaptors...