Search results

My question is, did Ford make two styles of rear differencials for the 60hp and the 85 hp motors. i oewn o 60 horse power 1938 Ford todor and I was wondering if the parts match between the two. I would like to change the ratio from a 4:11 gear to a more easier gear like a 3;55 or less. please...

I'm liking that combo, not worried about drive shaft as of yet. thank you for the reply.

I'm just asking for some combo's, I have a shot at a 35 motor as of right now with a 39 ******. I like the idea of a 59A motor with earlier ******. Thank you nfor your insight

I have a 1938 tudor standard and I was wanting to swap out the drive line. I'm asking what fits what in regards to 1935 to 1946 motors and transmissions. Can I match up a 35 motor to a 39 trans or a 36 trans to a 1946 motor. Please advise me. Thank you

Thank you guys for all the info. Will try soon

I was wondering if there's a schematic of the ignition tumbler and steering lock assembly. Need to remove the key lock because it is hanging up. Please advise Thank you the car is a 1938 tudor standard

Thank you for the insight

I was just wondering how much trouble would it be to swap my 60hp flattie and ****** out for an 85hp or 125hp flattie and transmission. What are my options for the easiest swap. the 60hp is just not getting anymore, but I do like the car I'm driving which is a 1938 Tudor standard. Please advise...

I was wondering what difference there is between a 60hp transmission and a 85hp transmission? wanting to swap out motor only if I can get away with it. Thanks

No I was just wondering about the center support bearing. Not too worried about the length. Thank you cas3

Could someone enlighten me if all drive shafts for torgue tubes are the same diameter or is the infamous 60hp drive shaft a smaller diameter. Thank you

Thanks for the heads up about the channel. soap and clean of rust and old seals.

Could someone help me about a 38 windshield frame seal. I have a B.Drake one and it seems like a real struggle to seat it. Any help would be appreciated.

I don't want to take them out I just want to know they rotate???/ Right hand thread or left hand thread to open them up. thank you

There is no drain **** on the radiator ford38v8. there is only two petcocks under the heads toward the front of the motor. Thank you for your reply

I would like to know if the petcocks on either side of the motor for coolant drain is a right hand or a left hand thread. Doing a head gasket replacement and I need to drain the motor. Or should I leave well enough alone and pull the lower hoses on the radiator. please advise Thank you

Thank you for that info..

Hello everyone, I was wondering what lubricant I should use in my 38 Standard witn a 60hp 3 speed transmission. Should I use 600w oil or the modern version of gear oil-85/140 w. Thank you

parts availability thats all. I can get it fixed but its way too costly. thank you for the reply Kurt.

guys, I was wondering if it's possible to change a clutch for a 60hp motor that comes with a 8.5 clutch to a 9 inch clutch and pressure plate assembly. this one is giving me fits as to what to do. Any suggestion would help or am I doomed to stay with the 8.5 clutch and pressure plate. thank you