Search results

Terry, I just ordered it, thanks.

Great help guys, thanks so far! I just got out the sector shaft seal. Is it possible that this cork sealing is the right one for the old metal one? It was included in the set and until now I don't know where to put it :-) It's the only one left and it fits perfect over the sector shaft. Thanks...

Hello from northern Germany, I am rebuilding my steering gear with the set from the early ford store. I pressed the new worm gear onto the shaft, but then I saw the housing for the cross shaft? has also two wheel bearings that have to be changed. Do they also go out with a hydraulic press? And...

Very cool guys, thanks!

Hello from Germany, the pipe thread from the side of my block ist damaged, I can't get it out. Is this the way you hold the oil pump in place without the tool? And while the paper holds the pump, you put the oil pan back in place? I can't believe that the paper stays in the engine? Is it...

Hey guys, thanks. Tim, unfortunately, it has no columbia 2speed. The seller of the car put new coil and distibutor in it, so I want to drive the 6V for the next time. The Lincoln will get a bit lower, the rest will stay as it is. My Ford went another way with a 284 Flatty and some other fine...

Hey Guys, I was already thinking who will ask the "why-question" :-) 1) I want to change to 12V in the future 2) in Germany you have to have turn signals and warning lights. Most of these relays do not work with positive ground. 3) I want to have it simple (my simple) I already did the...

Hello from the north of Germany. Besides my 1936 Ford Cabriolet I just purchased a 1937 Zephyr. I just made an application for the Lincoln Zephyr Owners Club, but it takes time to become a member there. So this is the story why I write here and hope this is OK for you. The Car is completely...

Hello @ all, the windshield is out :D Thanks to all of you! I bought a tool set with a metal cutting wire. Now I have to paint the frame ;-) On my frame there were no screws at the side thar hold the windshield frame. As you can see in the pictures, there are two screws at every side, but...

Thanks Guys, I will try and report:-)

Thanks Dan for your help from many thousands kilometers away :-) All the screws are already out, the windshield doesn't move at all. Normally there is no glue here, right? I think someone did so... Or is there any other possibility why it is stuck?

Good evening from the north of Germany. I have to change the seal of my windshield because my feet get wet when it rains...:-( As you can see, I disassembled all the mouldings. How does the windshield come out (without breaking)? Thanks, Conrad

Yes Steve, I think this is what I will try. Originally, there where just these spring clips I believe.... Thank you guys!

Thanks, but my red one went behind the trim...I grinded it off so the painter now has to paint it blue and then the pinstriper can do his work.

Hello from the north of germany. I want to remove the stainless steel grille trim from my Cabriolet. I could not remove it by hand or with a platic tool. From the other side there are screws. Do I have to unbold the screws to get the trim out? Without dismounting the entire grille it is not...

Thank you guys, I already converted to 12Volt. I think I will buy a cheap tach just to check the rpm and then disconnect it.

Hey Tubman, the engine could go more, but i was too afraid to try ;-)

Hello from Germany, this is my first post here… I have a 36 Cabriolet with 4.11 rear, 39 gear box and a french flathead. Without the Mitchell I was not able to drive more than 50 miles an hour. Now 65 miles are fine, although I do not have a tach connected. I bought it from Macs, and they...