Search results

Trying to adjust my new brakes. Front drivers side not adjusting . Took off brake rod. Noticeing some play in the brake adjusting arm from the 15 degrees Should there be and play( 5-10 degrees)in the brake adjusting arm after the 15 degree forward angle? Remedy if a problem

May bring this 30 31 commercial shell to Rhinebeck- Not AA $155

If the weather ever changes. I would like to paint the top irons on my roadster(31)... Do i just remove the plated screws to do this?

Should the headlight switch on the steering wheel have a click when changing to high-low or off or is it just a slide into the new position? ( New harness from Brattons)

Working on disassembly of rear brakes. (31 Roadster). Removed backing plate bolts. E-brake plate will not come off. What is holding it on?

New wiring harness--- 6 volt - non signal light- tail lights on with low beam and high beam No tail lights with cowl lights Should tail lights be on with cowl lights ? Possible reasons no tail lights with cowl lights. Thanks

I have been told I could have and engine that had been modified back in the 60's. I'm told it has a pressurized oil system. but the interesting thing is it has a B head on it. ( four stud water pump). I don't know if I want to mess with the engine assembly or if the head is worth anything...

I have 2 what I believe to be original headlight sockets. Pictures shows a repro on the left and 2 different length sockets. All are single bulb 2 filament. any thoughts?

Looking for pictures of how 30\31 headlights are wired eliminating spring connections. If spring connections are replaced with bullet ends on the bucket side. What holds the conduit in place. That little dimple/pimple does not seem to be enough to hold the conduit in place without spring...

Picked up this 31 Roadster just before the winter and have not had much time in the New York unheated garage to play around. Do you think I need a new wiring harness or just a little electrical tape. Someone did a nice job of brazing the fan. Can you see it? Seriously. Reading a lot of posts...

Does Mafca or Model A restorers club keep a record of serial numbers of members cars?

Near mint 31 shell with both inserts. Two very little creases. No welds or cracks. Hard to find in this condition

Working with a friend to get his 30 coupe running. Got caught in a fire years ago but it was pulled out by the firemen . It was running before the fire. We wired it up. Good spark rotor turning NO COMPRESSION ALL CYLINDERS. Timing gear good. Any suggestions as too troubleshooting.