Search results

Looking for the filter that attaches to the Late 1931 Zenith side bowl carb. (Used for the indented-firewall late 1931 M0del A's)

Here is a large booklet of illustrations of Model A and early V8 Fords dated 1974 by Dom Pacitti. Dom was an executive designer and artist for Ford Motor Company. These are 12 x 18 inch illustrations on heavy paper. There are a total of fifteen. Here are pictured some examples. This a rare...

Here is a large booklet of illustrations of Model A and early V8 Fords dated 1974 by Dom Pacitti. Dom was an executive designer and artist for Ford Motor Company. These are 12 x 18 inch illustrations on heavy paper. There are a total of fifteen. Here are pictured some examples. This a rare...

Does anyone know which issue had the article about cleaning Zenith carb passages with a paper clip? I think it was in the "Restorer".

Here is a nice model of the Model A pickup for sale. About 7 inches long. $65 plus actual shipping cost.

Here are three finished Hubley Model A's done correctly by a restorer of four former fine point actual Model A's. Note: Fordor is by Scale Models who bought out and used the Hubley molds. $150 each plus actual shipping cost.

Here are three upper plates that have been re-cad plated years ago. One is modified for later points. $20 plus shipping.

Does anyone have any fabric with various Model A's as shown in the attached pic? It was sold many years ago. If you have some you're willing to sell, please let me know.

Does anyone have any fabric with various Model A's as shown in the attached pic? It was sold many years ago. If you have some you're willing to sell, please let me know.

Does the 400A Convertible Sedan and the Victoria use the same rear seat? I'm referring to structure obviously not upholstery.

This is an original cast iron pulley for those who like original parts. I believe it is an Autolite as it has the Al logo on the back of the spoke. It has been sandblasted and primed. Short taper - good, some original casting pits, and pits on edge. #7 on backside of spoke. $20 plus shipping.

Here is an original cast iron pulley for those building fine point cars or who like original parts. I believe Autolite made it as it has an Al logo on the back of the spoke (AL 8). It has been sandblasted and primed. Short taper - nice, some original casting pits $20

Here are three original seamed gas lines. All three for $30 plus shipping.

This is a pair of used original emergency brake levers. Included are the original thick headed bolts. Media blasted & primed. While these are the nicest pair I've owned for surface condition (no rust pits, gouges, nor spring wear marks), the holes need to be welded & drilled. Might use oversize...

This is a very nice original gear that goes on the driveshaft to mate with the speedometer drive gear assembly. $20 plus shipping. Now $17.50

These are nice Michigan license plates to register your car with year of manufacture. 1960 pair $65 1965 single $30 1966 single $30 Plus shipping.

. ...

This is a decent pair of original rear fender brackets (some pits) for Tudors, Fordors, and standard phaetons, etc. $30 plus shipping. Now $27.50

... ...

Here is a set-up I made for a club seminar on adjusting brakes. Brake rods are shortened to enable the set-up to fit on a table. Adjustable parts are coded in yellow. You could do a seminar for your club and use the parts afterwards for your restoration! $250 (backing plate, spindle, operating...