Search results

Stock height stanchions. I believe these are zinc die cast. A few extra holes. Nice shape. Price does not include shipping. Thanks, Mike Bailey 586 291 7299 or PM me

SALE PENDING Hate doing this, but something has to go. 1929 Ford roadster, Brookville panels except for original cowl top, '30-'31 hood sides, and original grille insert (has Vintique shell) 1932 Ford frame, JW rails, built by Ionia Hot Rod Shop. Boxed with belled holes, X member. Dropped...

One left and one right door. Both relatively rough, but pretty solid. Not much rust, but quite a few dents, cuts, and holes! These will require some work to make them usable, but they can be saved. Price does not include shipping. Mike 586 291 7299

SOLD Very original car that I purchased off the original owner's grandson about year and a half ago from a small farm near Saginaw, MI. Car hadn't been on the road since 1957. You can read the story here.... http://www.jalopyjournal.com/forum/showthread.php?t=441644 Car is almost all...

Went and looked at this engine today to potentially put into my '32 Tudor. I have a rebuilt flathead V8 trans I'd like to hook it up to. The seller wants $500 and wont budge on the price. It turns over freely, but he hasn't heard it run. Is this a truck engine? Any other comments? I am...

My steering gear is leaking lube badly on my Tudor. But the steering feels pretty decent. I'd like to just replace the gaskets and give it a look inside. I pulled the steering out of the car, and pulled off the four nuts of the sector shaft housing. Is there any trick in removing the sector...

SOLD!!! Brookville parts. Slightly used, not painted, still has Brookville's primer on everything. Switched over to a trunk, and this is what I have left over. No dents, nice condition! Rumble lid (has two small rectangular slots on inner - see pic) Latch Hinges Roll pan (has a few extra...

Posted this same question on the Hamb, so sorry for you guys that have already read about this. My '32 Tudor has some pretty rusty rear quarters in the wheel well area. I would like to repair these, but I don't believe there is a Sedan version of the panel available, only the coupe and...

Is there such a thing? Would like to run the stock water pump (3 bolt) with a higher compression head on by B. Everything I see has 4 holes? Thanks, Mike

Guys, Gotta '32 B engine that I would like to perform a compression check on. I have the fitting to fit the spark plug hole and the compression gauge (thanks forever4). Should it be done with the engine warm/cold? What is the "allowable" variation between cylinders in pressure? Can I do it...