Search results

I have been working on my 53 Flathead V8,and the thermostats are no good. I have yet to drive the car and was wondering if I could run the motor without the thermostats for a while until I determine if the engine is ok? I know they are inexpensive and The 180 degree seems to be the correct one...

I have a 53 flathead and some of the threads on the carburetor are in rough shape. The fuel line tightens up but leaks. Any ideas besides getting a new top piece for the carb? Any help is appreciated as always

I have a 53 Ford Customline v8 and took off the fuel pump to clean and inspect it. I did not notice that the rod was different on each end. Does the end with the 2 grooves go into the engine? I do not have a picture of it at this time. Any help is appreciated

I have a 53 Ford with a v8 flathead I purchased a diaphragm for the fuel pump and was taking it apart. I was wondering how to get it off. I see it has a slot on the shaft that connects to the pump. Do you have to push that pin out and take out the spring? I didn't want to make a mess of the...

Just replaced master cylinder ,wheel cylinders ,and hoses on my 53 Customline V8. The master and the cylinders are made by Dorman. In an earlier post I was having leaking issues but have that under control. Thanks to all who replied. When trying to bleed the brakes I could never get the pedal...

I am currently working on the cooling system and had my original radiator tested. I knew it had a leak and the radiator shop told me that it needed to be re-cored (which they could do) or buy a new one. They recommended a new one as an option. Any suggestions?

I have recently purchased a 53 Ford Customline 4door with Flathead V8 3 speed. I replaced the master cylinder and wheel cylinders.When I put the fittings back on the front of the master cylinder it leaks between the washer and master cylinder and between fitting. I did not have new washers or...