Search results

Is there anybody that has or reproduces door lock cylinders for the model a cars?

Where dose a model B water pump bottom out in the head? On the shaft or on the impeller? Thanks

What is the correct head gasket to use on a model a police head?

Any feed back on Bobs needle bearing universal joint. Good, bad?

Anyone in vicinity with a rear axle for a Model A? Traveling from Michigan and broke down in Bayfield WI.

I went to put a set of Kelsey hays bent spoked wheels on the back of my A and they would not fit. I have Mikes cast iron drums on the back. There was about 3/16s interferance with the drum. Is the pressed steel drum that much smaller? I always thought that Kelsey hays 16 inch wheels were...

I have 59ab in a 1941 pickup. Bought it in 1984. The engine is a 1953 mercury, all standard bore, mains and rod bearings. It always ran on the hot side. I put in thermostats, washers to slow the coolant, steam cleaned out the block and heads, nothing helped. I gave up on it. It sat in the barn...

I put a new 6 volt electric pump to replace the mechanical one. I hooked it to the ignition switch and it pumped fine with the ignition turned on. The engine starts and runs for a minute and dies. After searching and cleaning wires checking voltages I found that the pump stops as soon as the...

Does anybody have a schematic of a AA four speed transmission? Thanks JB

I have a model A and run the power to the coil without a resister. I also have a 53 mercury engine in a 41 ford pickup. The ignition has a resister to cut the power to the coil in half when running. My question is WHY? JB

Is there a front and a rear on the front axel or is the axel symetrical? Also are the kingpins right and left or can they be enterchanged? Thanks JB

I took my A for a 20 mile ride today and just for the fun of it put my hand on the banjo to see how hot the oil was. It was warm enough that I couldn't hold my hand on it for more than 20 seconds. It was only 75 degrees out and I had been running at 45mph. Does this seem right? It is full of...

What is the best way to hold the camshaft to put 100lbs torque on the nut that holds the timing gear?

I broke a starter spring and would like to know the right way to install a new one. I have the drive on the starter shaft and one side of the new spring bolted to it. I put the key on the shaft and slid the small piece on the shaft and onto the key. Now I need to rotate the small piece to attach...

I have a Model B carb with the round float in it. What is the float height specs? I am having a hard time getting the engine to idle. It likes the stall when coming to a stop. It is a B engine with an A intake and exhaust. Thanks JB

I rebuilt my steering box on a '30 coupe. I centered the steering gear, the pitman arm was vertical to the frame, and the drag link was too short. I measured the center to center of the pitman and the spindle arm with the wheels stright and the steering gear centered and it was 23 5/8". The drag...

I am rebuilding my model A steering box. It is a two tooth box. I put a new nos sector in but used the old worm. When I adjusted the box according to the Andrews book, I can get the movment out of the pitman arm in the center position. But when I move to the right or left 1/2 turn, I can shake...