Trying to get window crank installed but cannot figure out how to depress the spring and get escutcheon, handle and pin installed at the Same time, is there a trick to this?
I have spark at the points but no spark plug spark, using a test lite batt, side of coil lite shines bright, on other side of coil lite is quite dim. Is coil bad and why no spark at plug?
Ok, using a digital voltmeter, set on 20v dc. Wiring disconnected output side of cut out reads 8+ volts. Connecting wiring to cut out to check voltage the volt meter goes bannanas. What is going on
Would like to see a close up photo of exactly how the piece I call the belt rail, (the one between the rear cabin panel and the rear deck) is attached at the door posts, seems to fit somehow into the latch pocket area. I do not have an original, it is a re-mfg made quite some time back, so no...
So my battery reads 6.3 volts, but when I hit starter it barely turns over the engine, acting as if the battery is dead, where should I look for a problem? Battery, ground connections??????
Left garage on a four mile cruise, two miles in, engine cuts out and restarts happened second time, restarted, third time no go, no lites, no horn but turns over. Where to look, terminal box, switch?
Just curious, how many miles do think your A has travelled since it rolled off the assembly line? Cars certainly would not have annual mileage as we have today, and certainly as the years rolled by mileage would have been less and less.
Gentlemen, I there a consensus of opinion as to whether hood props are a real asset, and if so, in the expert opinion of those who have them, which is the best??
Working on my tailite began to notice an odd smell, was tired and called it a day, disconnected battery. Next morning,, returned to scene of the crime. Again odd smell, discovered repop tail lite switch shaft had became stuck inside housing and was getting quite hot. Is this a common problem...
So it appears the trim pieces are all installed prior to installing the panels onto the door? Are the tangs pushed thru then bent over or do they need a backing plate. I am a little confused on the installation