Search results

I've got all the other major issues sorted out on my Model B 32 truck. The only one left is the trans. I haven't pulled the cover off to look inside yet. The only real issue is it pops out of second gear when I let off the gas. If the engine is under load it'll stay there. I'm no trans...

In the attached pic what are the two items on the upper dash above the speedometer indicated by the red arrows? I've seen them on several stock trucks and always wondered what they were for. Thx guys.

I'm fighting an exhaust leak at the end of the exhaust manifold to the first pipe heading towards the muffler. I've ordered a new B-5250 pipe from Macs and their website says there is a gasket or coupling that goes between the manifold and pipe that is available at most parts stores. What...

This is a question about the gasket that goes down each side and across the bottom of the frame. Not the hinge gasket. Looking at the attached pic which side goes towards the windshield frame? The top or bottom?

I picked up one of these brake switches from Macs. Hoping I could make it work on a 32 Ford with mechanical brakes. Trying to find a mounting spot for it in the brake pedal area. Anybody do it before and can give me a pic?

I've got a windshield frame for a sedan but the lower bar is pretty rotten, like most of them are. Repros from Macs are really expensive but repros for the 3 window are cheaper. My question is: Is the bottom bar between a sedan/5 window frame and a 3 window the same? If so I'll buy a cheaper 3...

Can anybody use these? One side is broken and would need to be repaired. $50. You need to pick these up. No shipping. Located in Calgary. Email me at steamticket2004 (at) yahoo (dot) ca

There is no adjustment at all in the hinges is there? I can't see how there could be any. The top corner of my door hits the cab yet the bottom has a least a half inch gap. Do I just try to adjust the door into the position I want by flexing with some blocks of wood or something?

Does anybody know if the brackets that join all the wood together on a 30-31 coupe are being reproduced by anyone? You see the rear brackets on ebay occassionally but never the front or middle ones. Surely not all model a's survived with those pieces still there. I'm looking for a set.

I was on the hunt for a 32 Model B spider gear. The only place that I could find it at was these guys. They seem to stock some hard to find things. Hope this helps someone out there.

Looking for a Y spider gear for a 32. All I can find at Mac's etc is a cross spider gear. Anybody got one?

So this is what the race looks like on my 32 axle. Obviously thats no good. Over at the Hamb it was mentioned a sleeve might be the way to go. Are there more than one type of sleeve? Any better than others? Also the pinion on my rear has a broken tooth. is the pinion for a late model A the...

Took my drum off and holy crap everything and I mean everything is soaked in oil. I also noticed the shaft moves a lot more than the other side did. The seal has to be shot in the end of the bell correct? I've never had one of these apart so I'm just learning. Watch the video in the link and...

Just a quick question about the clevis and pins at each wheel for the mechanical brakes. I assume they should be tight and have no slop in them. Mine are quite sloppy proabably from the 80 years of use. By the time all the slack gets taken up the pedal has moved quite far and hasn't even started...

I've got a 4 cylinder engine. All the flathead motor pics I found show it installed this way with the cone of the rubber facing up. However my crossmember is dished making me think the rubber should be facing cone down with the big washer between the ruber and engine. Or have a I got this...

Some of you would have seen this on the Hamb already. Picked it up this week about 2 hours north of where I live. A sweet old original truck. In pretty good shape. I'm thrilled to have it.