Search results

I am looking for the stainless ring that goes around the face plate and the bottom bracket that the locking hubcap assemble hooks into for my 1935 coupe. -shad

I'm wondering if someone as a template for the wood shelf? It goes over the spare tire on a 37 tudor sedan touring (humpback). thanks -shad

Im looking for a right hand splash pan for my 1937 tudor with the 60HP, Ford part # 74-6775. The 60 hp had different splash pans than the 85 hp did.

If anyone has a Glove box handle for a 1937 standard, I am in need. Thanks for checking -shad

Is the floor mat for the 60 Hp different than the 85 Hp? I ordered the one Dennis Carpenter sells and the hole for the shifter is off by about 3-4 inch's. If that's the case where would I locate the correct one? Thanks for any help you can provide. -shad

Can i get some advice, where is the window crank for the rear window clocked when the window is in the closed positíon?

Can someone please tell me which way the lower door seal is installed.

Hello,. Can I get some guidance on the routing of the park brake cable where it enters the body. Does it share the hole with the speedometer or some where else?

Im starting to work on the interior on my 37 tudor standard touring. I understand there were only two different selections available. Two-tone Taupe Mohair and A Bark Cord. Attached is a picture of what I have. Im thinking its the Mohair? But my looking for some input. Also where would...

Looking for a passenger side fender that will fit a 1957 skyliner

Has anyone else had an issue with a set of new running boards from Bob Drake being to wide? I have the rear fenders attached to the body, and the running boards stick out approximately 3/4 to 1 inch wider than the fenders where they attach. This issue is on both sides of the car.:confused:

I'm looking for a restorable or restored grill for my 37 tudor standard. Thanks for any help you can provide. -shad

So, found another barn find...But its a Chevy, 1931 coach. So trying to school myself on this find... Can't seem to locate a forum like this one for Chevrolets. Anyone here with knowledge on this gem? Are parts available, What are the values on these? -shad

So I have finally got my LB block assembled and installed in my 35 coupe. The resistor under the dash for the coil gets really hot, so hot the insulator base starts to stink. I believe it is functioning properly 6.3 volts in and just under 3 out. And ideas. Wiring is all new. And the...

Working on a LB going in a 35 coupe. And I don't have the correct Stromberg 48, or 97. I do have model's 91-99 8BA 59 Can someone tell me the difference between and the one that will give me the best performance? -shad

Hello All. I'm working a my LB rebuild and have questions, I have both a cast iron and aluminum intake. I understand the aluminum is the "right" one to use, but when I go to install the sleeve you slide in before the fuel pump mount stick out too far. Or is this only installed with the...

Looking for a pair of rear shocks for a 1937. Looking for rebuildable cores -shad

Look for the passenger side seat track for a 35 5w coupe. I have a picture of the drivers side. (attached).

Can some one please explain how you'd gain access to the space behind the seat on a 5w coupe. According to the 35-36 ford book, this space was accessible through the front of the truck. But the issue is the previous owner has the interior redone, and it looks to me like they decided to not do...

Looking for advice. I need some floor and trunk sheet metal work done on my 1937 Tudor. Looking for the right body shop somewhere in Minnesota, that others have used and are happy with there work.