Search results

This 1950 Ford rear bumper filler came off of my dads Casino Cream 1950 convertible that he bought in 1951. This was taken off when he bought the car and a new Continental Kit was installed. This was in his garage since then. It has a crazy amount of factory undercoating on it! I don't believe...

PENDING Original 32 Ford grille molding and frame. Original grille shell not for sale, it's only pictured to show how the molding fits.

Two 38-48 Ford Flathead oil pans. These may fit 32-48 but I'm not sure on the earlier years. Pick up only. $75 each. Ph. 419-234-2628

I have (3) 39-48 Ford Flathead crankshafts for sale. These are from Flatheads I parted out over the years. Two are standard and one had previously been turned .010/.010. $100 each. Ph. 419-234-2628

Used 32-34 torque tube and driveshaft. This was in my 32 until I went to an open driveshaft $200. NOS 32 33 34 Torque tube $450. Pick up only. I will be selling quite a bit of pre-war Ford parts in the coming weeks. Ph. 419-234-2628 or PM. NO TEXTS

1932 Ford Original V8 radiator. This was in my dad's channeled 32 five window when he gave it to me. I had it boiled out and checked in 2010. I ran it a couple years like that with no problems. The upper outlets have been straightened out for the channel vs the stock angled down. Also included...

1932 Ford firewall parts. These were left over from taking out 3" of channel out of my 32. Pick up only. I will be selling quite a bit of pre-war Ford parts in the coming weeks. Ph. 419-234-2628 or PM. NO TEXTS

Set of 4 NOS 39-41 Ford Hydraulic brake backing plates. These come with the brake shoe anti-rattle clips. Pick up only. I will be selling quite a bit of pre-war Ford parts in the coming weeks. Ph. 419-234-2628 or PM. NO TEXTS

Four 16x4 1940 Ford wheels. I believe these are 40 only. The two with tires are off of my Dad's 51K miles 40 Coupe. The other 2 I picked up at a swap meet. They all look to be in great condition. Pick up only. I will be selling quite a bit of pre-war Ford parts in the coming weeks. Ph...

I'm looking for an original Trico 1932 Ford KSL 511 closed car wiper motor. What I need is a good main shaft. So a core will work even if it's not rebuildable because of pitted pot metal. I have attached pictures of my wiper motor to help you in identifying what I am looking for. My main shaft...

***SOLD*** 1932 Ford rear frame crossmember in very nice shape. Not altered that I can tell, even around the exhaust hole. Over all very nice. Just a little rust on the ends where it's hidden by the frame. I don't see any other pitting. $125. Ph. 419-234-2628

One 1939 Ford rear brake drum for wide 5 wheels. This came off of a 39 rear that I parted out. I don't know if this will fit a 36, 37 or 38, I assume it will but use your own knowledge there. It measures 12.018". Axle bearing and axle taper surfaces appear excellent. Has a small chip on the...

39-42 Ford Flathead left (drivers side) rear brake backing plate. This will work on 32-48 Ford banjo rear ends. This has been glass beaded and primed with vari-prime primer. Very nice condition, just a few small areas of light pitting as shown in the pictures. The emergency brake cable tube...

Pair of 50-51 Merc flathead waterpumps with narrow belt I had these listed as truck waterpumps, but have been told they are 50-51 Mercury flathead waterpumps with the narrow fan belt. The shafts spin freely but I would have them rebuilt. $50. Ph. 419-234-2628.

This is a pair of 8ba Ford Flathead truck waterpumps with the wide fan belt. The drivers side is heavily pitted where the radiator hose attaches and the impeller. The shafts spin freely but I would have them rebuilt. ***SOLD***. Ph. 419-234-2628.

***SOLD*** This is a matched set of 29a rods from the same engine. I took these out of a 59a that had a cracked block. They were hot tanked. No gaulding or heat dis-coloration. I checked the bushed end with a NOS set of .003 oversize wrist pins and they wouldn't go in, so I can say they have...

***SOLD*** This is a pair of 39-42 front backing plates I took off my dad's 32. They had been on the car since the early 50's, and my dad brush painted them around '56. That is the paint on them now, so real patina. Also 5 brake shoes and some small parts including a car set of Nace adj nuts...

*** SOLD*** A nice pair of 42-48 Ford front spindles. Not pitted, just a little surface rust. These accept 39-48 brakes. Good bearing surfaces and threads. If you are using cross steer steering, please take note that someone has cut off and flipped over the end that the steering relay rod...

1 pair of speedway water pumps I bought new (bright red paint). Only used a couple hundred miles before my block cracked. Cost $180/pair new. $100. 1 pair of used speedway pumps (dark red paint). turn free with normal resistance. $40. Ph. 419-234-2628

2 sets of main caps from 59a engines. I took both engines apart myself and kept each set separate. Neither engine had spun or seized bearings. Great condition, not rusty. Pictures are of one set. $50/set. Ph. 419-234-2628