Search results

Thanks ford barn

Thanks Ford Barn

Thanks Ford Barn

sold thanks ford barn

Here is a decent looking model t honeycomb radiator. Inside looks very clean at the tank. Core looks decent and might have had a small leak repair on the front right side. See picture. One lower mount looks like it was soldered on also. Small dent in top tank on the right top side. Hard to see...

Thanks Ford Barn

Here is a very nice Ford truck F1 trans crossmember. Good for a model a V8 build. I have had this for about 25 years and will not get around to using it. Maybe someone else can. It is in very nice condition and not cut up or butchered. I also have the pedals listed separately. If your building a...

delete, thanks ford barn

sold, thanks ford barn

Looking for a used or NOS 1947 ford coupe throttle cable for a V8 flathead.

Found. Thanks ford barn.

Sold, thanks Ford Barn.

Sold, Thanks ford barn.

Did not want to step on stillwater's thread so here goes. I have a pair of 53-56? ford pickup hubs. I was given these along with the aluminum Buick brake drums that i installed on my flathead roadster with 40 ford backing plates and spindles. The problem is that they don't go on over the entire...

Looking for any advice on a set of new pistons for my 46, 59AB that i am rebuilding. 80 over. Much difference in brands out there? What have you guys used?

https://journal.classiccars.com/2018/10/07/kansas-city-ex-convict-indicted-for-running-classic-car-scam/?utm_campaign=20181008&utm_content=20181008_ds_advertorial__featured_dealer_with_logo_inventory&utm_medium=email&utm_source=zaius&zm64_id=cmFuc29tc2FuQG1zbi5jb20%3D

Not sure if this was posted. Apologize if it was. Unfortunately, we have no other choice but to cancel the August, 2018 Big 3 Swap Meet, the vendor support just isn’t there, and the expenses are too great to risk moving forward. Please post this to the website, adding that any vendors that...

Not sure if this was posted. Apologize if it was. Unfortunately, we have no other choice but to cancel the August, 2018 Big 3 Swap Meet, the vendor support just isn’t there, and the expenses are too great to risk moving forward. Please post this to the website, adding that any vendors that...

--------

Here is a 1929 short block motor. Supposedly ran very decent when removed because of the typical freeze crack in the front of the block. See pictures. If I were to keep it, I would braze it up or JB weld like so many do. It has 015 pistons in it. The cam should be replaced as it is pitted. Both...