Search results

SOLD Early Ford top loader internals. Really nice condition but I no longer have need for them. No chips or excessive wear observed. Shifter top included but will sell separately.

May be a shot in the dark but....Looking for a really good single 16x5x5-1/2 bc steel wheel. Please no serious rusted or dinged wheels. Have a bent wheel needing to replace. Would consider a matched pair. Obviously would prefer something close to me.

Updating my AV8 flathead. Installed two rebuilt Stromberg 97's on an Edmunds intake and have tried synchronizing the carbs with no success. Seems the front carb is the only one responding to idle adjustments screws. I can put my hand over the rear one and the engine continues to run albeit...

SOLD Please delete Really nice dual carb Fenton intake. No cracks, welds, stripped threads. Really just a great looking intake. Bought for a project that no longer is going to happen. My lose your gain.

SOLD SOLD Very clean top loader trans taken from my AV8 . Rebuilt by previous owner and i only put about 500 miles on it. No cracks, sludge, grease, or chipped teeth. Syncros look new. Had a slight grind going into second gear at times but probably due to my negligence. What you see is all I...

Need rear hub puller. Thanks

Third attempt at installing stats in my 42 Flathead. Just bought and tried NAPA 115 stats and cant get them to open in near boiling water. 180 degree my butt. Have and used infrared thermo. and this pissing me off. Had similar trouble with three different manu. Open fine using a heat gun so not...

SOLD...SOLD Nice set of ceramic coated Fenton headers for a flathead. One header has a grind mark on it but otherwise in excellent condition. Including discharge elbows for system hook up. Bought for my AV8 but had clearance issues with my Vega box. May consider trade for three carb set up...

Been chasing this gremlin for about a year or more now. Starting to think I am stupid. When I first ran this engine I didn't install stats and it continually ran on the cold side. Temps ran up to a max. 170 on a hot day at idle but frankly it never ran well until higher temps. Often had to run...

Cleaning up some parts from long storage. 49-51 FH Mercury Really nice pass side water pump. Looks either rebuilt or NOS as there is no scale or internal rust. Part #8CM-8506-B May be usable as is or ?..... $40.00 Generator mount looks like it needs some cleaning....... $20.00 Fan with mounting...

SOLD... Thank you Rich Here are a pair of original Model A headlight lenses with attached frames. Please disregard color of pictures as lighting was poor. Glass is embossed "Ford" parts and frames are as shown. They have dings and wear and should be considered driver quality. Thanks for...

Ok bought this rear axle assembly for my car. It's in great condition externally appearing as the owner suggested as a low mileage take out with virtually no rust and light peeling original paint. I was told it was a 3:78 ratio and the numbers stamped are 9/34 which should be correct. Sounds...

Still trying to learn new(old) things every day. What are the advantages of using Zephyr trans gears over the Ford gears? Thnaks

Looking for a model Number or manufacture number and source for the fan belt on my AV8. The generator belt is a B52 Gates but the fan belt has no I.D. Measures 5/8 x 37 inches. Actually called MACs and rep said they have no belts for a flathead? Appreciate any help

Car has been done for many years but I never installed the weather stripping on bottom of the doors. Gets a bit drafty in cool weather. Can any one clarify the proper installation and orientation of the rubber? Thanks

Now have the answer gasket under the cap...da! Dum me. Sorry I put his ad in the wrong place as well Is there a way to make this distributor more water tight? Filling the radiator and had overflow and wet the distrib. Obviously the car spitted and sputtered due to moisture in the cap. Concern I...

Found one thank you.....Anyone have an empty closed trailer going out to southern Caif for a pick up that can deliver my son's 66 Mustang to him. Pick up here in Wisconsin 54669 going to 93010 zip. Car is not a trailer queen and would say condition is a 5 out of 10. Tried several shippers to no...

My son found a complete 31 five window coupe that has been sitting out West in dry storage for over 15 years. No rust found but hasn't been run in that time so mechanicals are unknown. Interior ,glass etc looks great but needs restoration. Any input on value? We appreciate any and all input, thanks

Very nice fan and pulley assembly, 1939-40 blasted and painted, wide belt 15-1/2 diameter blades....$30.00 ***SOLD *** New solid core spark wire set removed from new rebuilt engine for electronic ignition install. 7mm solid core..$20.00 ***SOLD ***** Original 42 heads removed from new built...

Parts as removed from my 30 roadster Tack strip from rear of top. Not sure this is stock but it is a steel strip sandwiching a fiber core on which the top snaps were secured. Core should be replaced and probably could use additional work. $25.00 Misc. grab bag of top parts. Snaps, top prop...