Search results

Anybody have an idea what these hubcaps fit. They are chrome but do not show up well in the picture. Neither of them look like they have ever been installed since there are no scratches on the mounting surface.

After several years and lots of distractions, the 35 Phaeton is finally done. Just got the license plates for it and now for the 'shake down' runs. A few trips up and down the road to 'see what falls off' and it will be back rolling again. The first project will be to get the brakes adjusted. I...

I ran into something odd. Was there any difference in the floor pan width on the 35 Phaetons? I ordered a rear carpet to replace the rubber mat from one of the best known interior suppliers. I found that the carpet was too wide and hung over the aluminum door sills about an inch on each side...

I can't figure out what is causing this, so I'll ask for ideas. I have a 35 with the red fluid filled temp gage. It's probably original because the fluid has been red since 1975 or longer. The car has gone through being re-restored in the last few years. It was converted to 12V neg gnd. The...

Mounted a temp gage and voltmeter in the 35 Phaeton after its first drive in 15 years. I found a piece of sycamore and made this panel. I think it turned out pretty good. The red fluid in the temp gage would rise up to the top as the engine was cranking over - even before it started. It has no...

I'm looking for 2 non working 42-48 ignition coils to be used for cosmetics only. I'd like to find some junk ones so I don't mess up a good working one.

I'm putting a 35 Ford Phaeton back together that someone else took apart from the frame up several years ago. Could someone please tell me how the radio antenna lead is routed from the radio through the firewall. I assume that it goes through the firewall, but I can't find a dedicated hole. I...

I'm looking for the dial hand for e 35-36 radio. Richard

I'm looking for a for pointer needle for the dial on a 35 (may be other years) radio or if you have any suggestion of where I might find one, it would be appreciated. I've even tried to find a clock hand that would work, but all the clock hands that I seen use a different size post. I don't need...

I have an extra 55-56 T'Bird tach and am trying to decide whether to keep it (just in case mine quits) or sell it. Does anybody have an idea of what it would be worth. It works good, has a new lense and needle, good face, bezel. Two of the little screws that hold the bezel on are missing. It is...

Does anyone know someone who repairs/restores the Sparton 3 trumpet horns?