Search results

I have a couple of 41 thru 48 heater motors, 6 volt that need repaired, the kind that reverse for defrosters. Does anyone know of someone that can repair them. Thanks

Very nice 99% orginal 1938 Delux Tudor sedan (has dual exhaust,tube shocks and a warmed up flathead 59ab motor). Older restoration but very presentable, Maroon paint has some flaws on close inspection. Good wide white tires, beautiful uphostery and carpets, Nice show and drive car. Excellent...

I have 4 decent wide 5 rims for sale. $115.00 plus shipping. Fit 36,37,38,39 Fords. Some rust from sitting but would clean up nice. All have good hubcaps clips attached. Would like local pick up but would ship at buyers expence.

I have a good running 59ab motor that is presently mounted in a test stand. It shows 40lbs oil press. cold and when warmed up 20 to 25 lbs. at a reved state. No water leaks or cracked block. At some point in time it has been rebuild because it is bored to 3.250 dia or .060 oversize. It is in NE...

I went to a local swap meet Sun. and found a neat old V8 tool. It is called (valve clearance indexer) It works by removing the front mount dist., bolting this gaget on. Then cranking the motor to line up proper marks on the gauge example #2 (cyl) E (exhaust or I intake) set the proper clearance...

This was at Auburn, Called a Jensen, body was made in England, motor and running gear ia 36 Ford. One of three built Very unique piece.

I need for 46-48 heater, the small bracket that mounts to the dash for the defrost cable and switch. also need the defrost knob, cable and switch.

While at Hershey I bought a Holley carb. with the 94 logo and Holley 2100 no. on it. The dis. vacum advance is on the carb. base. What model crs and motors did this fit?? Thanks in advance. Dan

Set of 4, 16 in. wire wheels. These are very nice, blasted with no pitting. Pick up only or can deliver to Hersey. $375.00

Took the rear end out of my 46 today and the lower spring shackles are bady worn. This is the one the attaches to the rear end itself, the bushing in it is bady worn(oblong). Mac cat. shows a kit 21 A 5630A with rubber bushings on the spring side but steel on the lower side. Same as what I...

This is a complete running 1936 Ford, It is a correct detailed, show car motor, with Stromberg carb,Gen.with cut out, starter motor.the only thing missing are the fuel pump and spark plug wires, orginal transmission(the only flaw is the top right corner is broke can be welded or replaced)...

I recently bought a very nice 36 motor with complete running gear (trans, and rear end). The transmission plate says 18-2264769, When was that made?? Also how do I tell if it is an LB block. This motor is nice enough for a show car. The rear end included,spring, shocks, wheels, Ford Script...

In my 46 I have a badly bent rear axle, I have another good complete rear end thar Iwant to use. How do I determine what ratio this rear is. The only stamp I could find was a faint 3and4 on the flat where the tube bolts to the pumkin. I have heard that by counting the number of turns on the u...