Search results

Are spindles and steering gear the same? Thank you

Is it the same as a 1929 Roadster pickup front fender? Considering pulling the body, hood and fenders from an AA and putting all on a regular A chassis. Thank you

Looking for a source for a cap. Mallory distributor #2301105 Searching has revealed a MSD #225 Anyone know where I can find one......?

Top of the carb is off. Bottom on the bench with float chamber full of fuel. The link is in the hole for the most squirt. Almost nothing is squirting out. I am operating the throttle through full travel so the pump plunger is coming to the top. The check ball and (pump) inlet needle are free...

How many different coupe models were offered in 1937? Differences in them? Thanks

Has anyone heard from Tod recently? I have been trying to reach him via F/B but get no replies

Hello, adapting a later banjo (1940) to a model A. Is there a difference in the U joint cover or the bell that mates to the Model A trans? Thanks!

Wanting to ad centrifugal advance so wife can drive and not worry about manually adjusting. I have a Honda Civic points distributor I modified to fit. Want to keep reverse polarity as original. Can I wire the armored cable to the terminal on the distributor and leave everything as is? Thank You

Looking for a whole kit or just the rear mounts used

I am in need of a 32-36 rear axle carrier bearing, race and cone . Used is fine. Thank you

I need the apparatus that is below the box. The front cable and both rear cables attach to it

Try not to laugh. For reasons of my own I am considering putting an open or torque tube '40 rear axle under my Model A but want to retain the 4 wheel mechanical brakes. I am aware of the torque tube mods that need to happen. Soooo, why wouldn't it work when hydraulics can be adapted to model...

Got a B engine to play with. Number on flywheel housing is BB54081664. Just for fun can someone date this for me?

What closes off the area between the door and the sub rail. With my door closed I can see the ground through the gap. No other cars locally to look at. Thanks

I need a good or repairable door for my phaeton project, roadster uses same door.

What would be the correct colors for the banjo wheel and column? Thanks. FYI I did a search and spent an hr looking at every other steering wheel question....I gave up

I'm needing a pass side hand brake link to complete a corner of my project. Part number is 91A-2108. This is the link that goes from the forward shoe to the lever that actuates the brake shoes when you use the hand brake. It has a hole in the forward end and a slot to the rear.

Hi All, Im changing my 8BA to look like a 59AB. I want to mount my generator on the drivers side head rather than the intake. #1 Can I swap the front end plate and mount from an early gen to my 8BA generator? #2 If I do this will the belts line up using an Offy head mount generator bracket...

Need 59AB style Drivers side offset gen mount. Bolts generator to the head to make room for more carburetors

I am missing the mechanism that works the defroster/heat door on the top of the plenum. For lack of a better name I'd call it a cam plate with a mount to attach a Bowden cable from the dash controls. This is for an AC car probably a Comet would be the same. I'd be interested in the whole plenum...