Search results

Hello looking for the rear sub rail end for a 30-31 coupe. This is the part visable below the rear panel . Thanks

I have 41 ford with helmet style distributor, external coil conversion. This is positive ground so which wire goes to the coil is it negative from switch and positive to the distributor?

Nice solid coupe , restored in 1980s or 90s , just got new tank, brakes. Rebuilt carb battery, etc. Runs good . No rust to be found, stored inside. Only non original parts are the rare 3x2 weiand intake 97 carbs( runs center only) and weiand heads.cant get pics to load send email request to...

Nice solid original, redone in the 80s/90s stored inside for last 25 years. Recently got it running and driving . New gas tank, brake parts, rebuilt carb. Runs good in nice "driver" condition. Clear Florida title in my name. Only non original parts are Weiand heads and 3x2 intake , 97 carbs...

Looking for the chrome trim that goes down the center of the hood. Please email me at history350@gmail.com

Anyone know of a good how-to set up points on the helmet style distributor? I've replaced the coil and condenser but cant get any spark.

As a result of sitting for lots of years, I need to have the gas tank in my 41 coupe either boiled out or replaced. It's silted and rusted inside. If I can't find a local shop to boil it out , where can I find a suitable replacement?

Hello how can I tell if the car has been converted to 12v or not? I got a 41 Ford with little information about it and no battery in it. Also if it is still 6v, is it a positive ground system? Thanks

Hello , I just picked up a 41 coupe that's been sitting for a lot of years last tagged in 96. The Engine turns but it is " tight", the brakes go to the floor, etc. What should I do first to bring her back to life? Oil down the plug holes and let it soak, clean gas tank and lines out? About the...

Took the plastic off my newly rebuilt motor and found the crank pulley is strangely out of place. Is this to far out, and what could cause this? By the way this is the truck version of the crank pulley. Thanks for the help.

Rebuilt and in good shape, ran a few times only, then I took it off to use a downdraft setup. $175.

Moved to for sale area. Sorry.

Hello , I'm having problems with cold starts, its so bad that I've run down the battery trying to turn it over. Once it does start, it only will run on the choke for a few miles. Any help appreciated. Thanks Sent from my SM-G920T using Tapatalk

Anyone use a Pinto/ Mustang II 4spd on their Model A?(Borg Warner SR4) I believe it bolts up like the T5? Thanks

Anyone know why Henry chose to call his two door model a "tudor" other than the obvious play on words? And how does everyone pronounce it "two-door" or like "tudor" as in the English royal family?

Does anyone know why the 32 was a single year model when the A and those after lasted longer? Was it viewed less highly than how we view it today? Thanks

Hello I have a "9" and "4" stamped on the bottom of my banjo axle does this mean I have a 4.44 gear ratio? The axle is from a 1939 car. Thanks.

Brand new in the box, never used. Changed direction. $300 shipped in lower 48 us.

Hello I have an all original Tudor with a zenith- 2 carb, the issue is engine runs like it's rich all the time but the inside adjustment is all the way lean (to the right or clockwise) it makes the engine shake and spudder when not under load. Under load is ok, only seems to run good when you...

Early 1928 ford ar frame. In solid shape , provision for left hand brake. Frame only no other parts.