Search results

What color is this car? We bought this car to drive at the National in Toledo, and had a great time with it but now we are going to sell it because we need the room. The car runs wonderfully, great power, brakes, steering, everything. But before we put it on Ebay we need to know if it is Chickle...

I bought a Canadian built car and want to bring it to the US. Anybody have experience with this process? Is this a big hassle? Any recommendations of transporters that do this ?

Anybody know of a transporter coming from Detroit area and headed towards Washington DC?

Looking for a set of good styled steel wheels for a driver.

Are there any differences between the blocks, pistons and crankshafts of a 1932 and later (say 1934) 4 cylinder engines? In other words, are they the same engines? How can you tell the differences in the years of manufacture by looking at the engines?

Has anyone used the Optima battery hold down bracket that Mike's Affordable Model A Parts offers? Is it compatible with the stock cables?

I have obtained a Borg Warner 5 speed transmission with a spline attached to the tail. Supposedly, this transmission will fit a Model A with some modifications. Any idea what vehicle this might have originally come from? Anybody have any thoughts about using it, good, bad or ugly?

Need good useable windshield frame, for sedan or coupe or cabriolet, stainless or chrome. thanks 301-466-4278 Jerry

Is a 1928-29 Roadster top assembly the same as a 1930-31 Standard top assembly? I have a complete assembly that I am going to take to Hershey to sell, but I am not sure what year it fits. Are there any differences among the years?

Where is the best place to buy a 6 volt Optima Battery? Can these be sent through the mail, since they are sealed and do not have any acid ?

My friends are investigating the prospect of transporting 10-12 Model A's from Texas to New England. Does anybody have any experience with a company that can handle that many cars?

I have a 1929 deck lid with many dents which are hard to get out, and I was considering replacing the outer skin with a reproduction skin. There are several compound curves in the original outer skin, and I don't know if the repros fit and look the same? Anybody done this, with good or bad...

I have a 1930 Coupe, with an original Trico vacuum motor with the two screws on the small cover. The wiper motor shaft hits the outside frame surface, and appears that 1/2" spacers between the windshield frame and the wiper motor mounting arms would separate the unit properly and give space for...

Looking for shocks, 1932, prefer A code, thanks

Having had problems with the clutch chattering and unable to adjust it out, we are planning to replace the clutch with a V8 clutch. Where is a good supply source for a flywheel , pressure plate, and disc?

The generator on my 1931 puts out 20 amps, and moving the third brush doesn't reduce the output. What is the problem and how do you fix it? Thanks much

Have a 47 flathead running on a Holley 2100 with a Purolater electric fuel pump and a flow meter set at 2.5. Starts up easily, runs and drives for 10 minutes, then looses power and stops. With effort, it will restart but stops again. After waiting an hour or so, will start up fine, run another...

I am getting into a 1937 flathead and need the engine adapter that fits the KRW engine stand. Thanks

Looking for a 1928-29 rumble lid, thanks Gerald

My type 59 flathead has an Edelbrock tricarb setup on it, with a Holley 2100 in the center and two Stromberg 97's front and rear, which are not hooked up, it was that way when I bought the car, running only on the Holley. I want to get three carbs running, should I use three matching 97's or...