Search results

Hello Ford Barn: I need some help with my 1941 Ford flat -head V/8. I need to know when a starter solenoid is not working, and how to check it out to know when it is bad. And how to go across what terminals to jump it to get it in the circuit?. All help will be appreciated . Randall Hornback

Hi again Ford Barn Men, i have another question. I have a friend who has a 1957 Ford fairlane 500 390 V/8 Fordomatic. He says it is running about 5 miles fast on speedomeater, he has change the gear on transmission that hooks to speedometer cable it was the 19 thooth gear. He says it has the...

Need help, can any one post a wireing diagram on a 1957 Ford fairlane for me. Would appreciate all help you can post for me. Thanks as always. Randall Hornback

Hello Ford Barn: Need help again for a friend of mine, he has a 1957 Ford Fairlane 500 V/8. He says it has a F-E 1963 390 V/8 motor in it. He needs to know where the motor ID No. is on the motor block ?. So he will have more information on it. All help needed and appreciated...

I have a question on my 1941 Ford that i have had for about 10 years. It has been running fine and well, but now it sounds like it not missing but thumping or cutting out It is a flat-head v/8, i have been running it on low grade Ethanol when it started doing this, then went to high grade but...

Hello to Ford Barn, need help on repairing inside sunvisor bracket for Crown Victoria 1956. They have the hang down, because of weak springs, i know that someone knows how to make repair on these. All help appreciated on how to repair. Randall Hornback

Hi Ford Men, thought i would put 2 Pictures of my 1956 Ford Crown Victoria on page for you all to see. I have had this super ford around 23 years and have enjoyed it very much It has a 312 v/8 and ford-a-matic runs super. When me and wife take to car show or cruise we get alot of lookers, and...

Hello to Ford Barn Men. I have a friend who has a 1950 Ford flat head V/8, his oil gauge does not work on dash of car. The car runs fine, does not make any bad noise, where is the oil sender wire from engine block to gauge on dash in car.? All help appreciated...

I need help again, i have a 6 volt distributor coil for a 1941 Ford flat head v/8 ford. Can someone tell me how to check it out to see if it good or bad. Can you check the ohms from the top where input wire hooks up to the pig-tail on bottom that goes into the distributor, and what should the...

Needing help on a 1941 Ford Flat Head V/8 oil folter canister. I have the oil filter canister, it is like new with fitting on it but no hoses. I need to know what size, how long they are, and where do they go on the engine. Would appreciate photos and all the information you can help me with...

Hi to Ford Barn, i need help again. I am looking for a turn signal kit for my 1941 ford super deluxe 6 volt positive ground. Where is a super place to order this from, a kit with everything in it to complete the job from the front park lights to tail lights in the rear. With lever switch that...

Hello to all at Ford Barn, thought it was about time to show off my 1941 Ford Super Delux that i have had about 10 years.I am very pleased with it, me and my wife have great fun with it at car shows and cruses. It is is 2dr with flat-head v/8 that runs very good. Hope you all enjoy the photo if...

Hi i need a little help on finding a schematic for a 1947 Ford wonder bar 6 tube car radio. I dont see a model no. on the radio or a chassis no. Any help you can give me i will appreciate it very much. Thanks Randall...

I have a 1941 Ford Super Deluxe, i have some questions about the hot water heater that came with it. I understand how to operate the heater for heat, but what is the best way to operate the defroster. I know that the Motor has a two-way switch for heat, or defroster. How do you get the most heat...

Wanted, and looking for another car radio ********.I need a 6 volt 4 pin type, one that is working. This also is for a Ford car radio 6 volt postive ground.Zenith built this radio, the Zenith part no. on the ******** is 190-22. All and any help will be appreciated on this. Give me price and...

Hi to all, i am looking for a schematic for a 1950 Ford car radio. This radio does not have a model No. or chassis No. on the case any where, there is not a tube schematic on the radio any where. This looks like the top of the line radio for Ford. I was told it came out of a crestliner model...

Hi too all at (FORD BARN) I have a question i need help on. I have a distributor tester that was used on flat head V/8's, that looks similar to the K.R. Wilson. This unit has a bulb which has been broken mounted on the front edge of it also a wire coming off the front edge that has a clip on the...

Hi too all at (FORD BARN) i have to me a big question that i need help on. I have a distributor tester i have no idea who made it, it is not a K.R. Wilson, SUN, Allen,. It looks similar to a K.R. WILSON. I do not know how to post photos but if someone will will give me there email i will email...

Need some help, where is engine ground on 1941 Ford flat-head V/8 to frame of car.Would appreciate any help you can give on this. I want to make sure i have a good,good ground from engine to frame. Thanks Randall

I want a KR Wilston Distributor Tester. I need this for setting the points, and Timing on my 1941 Ford flat head V/8. If some one has this unit for sale let me know, i want one that is working and complete with light also working. Email me or post a reply and let me know price and maybe we can...