Search results

Anyone know the part number for non adjustable hydraulic lifters? Are they the same as the lifters used in adjustable rockers? Thanks in advance

Does anyone have a view they can share? Seems it changed in 1912? Thanks in advance

I am looking for a 1911 Steering shaft. Any leads would be much appreciated. I put $1.00 in because I had to put something. Thanks

Does anyone know why someone would put 8 carb to intake gasket on ? Also should the small hole on the bottom of the carb not be block

Some how mine rolled off the bench hit the floor and bent the spline. It is 3.375" in height 1956 Cruise o matic medium case anyone have one or any leads ? Thanks in advance

Some how mine rolled off the bench hit the floor and bent the spline. It is 3.375" in height 1956 Cruise o matic medium case anyone have one or any leads ? Thanks in advance

hello, seems like I have yet another transmission leak. The seal on the shift rod that goes into the side of the transmission is leaking.My question is do I have to replace that seal from the inside or is it replaceable without pulling and tearing down? Thanks in advance.

hello, I bought a rebuilt card from a gentleman in Eaton Ohio. I put it on and it is hard to start and barely runs with the choke out and the throttle all the way open. It will run for about 15 seconds and die. He said it was preadjusted, what am I missing? Thanks

hello all, I recently replaced the entire brake system new lines wheels cylinders master cylinder shoes turned drums. I can get a peddle. I can pump it up and it will hold until I release and then right back to the floor. This is the 3rd master cylinder thinking I must have got 2 bad in a row (...

Hello all, anyone have any ideas on reinstalling the hood hinge springs? They are a bear. Thanks in advance.

Hello, we have a 52 COE with dump bed. Can anyone show me a picture of how the cables are mounted to the PTO and the hydraulic pump? I think I have all the parts just tossed in a box and not sure of the exact configuration. Thanks.

Are the flat head in the COE's water pumps the same as any other flat head? Does anyone know a good source for them? Thanks

Ok so the previous owner removed the wires from the switch. I bought a new switch. The post are marked P - R . I have 2 B post and H also a post coming off the resister. so 6 post and I have 6 wires 2 are hot. Why would the switch have 2 battery wires going to it? Also I assume that the...

Hello, I need to remove 1 valve spring and guide. My question is can this be done with the engine still in the truck? Thanks

hello, is the headlight switch the same as on an F-1? FAA-11654-A? Thanks

hello all, we got in a 52 COE V-8 the belt is off the water pumps and generator .My question is how do you adjust the belt tension? It has to be with the generator but I must be missing something. Its a little tight up there by the way. Thanks in advance.

Does any have a picture of the washer nozzles showing style and location? Thanks

Hello, anyone ever rebuild their pump? Thanks

hello, We just got a 31 Vicky and it backfires a lot. Started checking everything and I have found that there is juice at the positive side of the coil constantly. points open or closed. I took the plate out and cant seem to find a short anywhere. It is a Nu Rex plate setup. Any ideas? Thanks...

I hate to sound stupid but how do you check the engine oil? I don't see a dip stick or and valves to open? also where would the serial # be located? Thanks in advance