Search results

Fuel gage stopped working and I need help finding the sending unit. Also would like to know what type of sending unit would work. Thanks

The inner race for the inner wheel bearing turns but is a snug fit. I was told it shouldn't turn and to remove it and add a few punches to the opening to make a tight fit and keep it from turning. My question is what harm does the turning do if any?

What is the desired thickness for front brake linings on a thirty six wagon? Mine are showing .15 of an inch. Riveted composition linings.

I have just started a rebuilt v8 with rebuilt dist, detroit lubricator carb, and early style intake manifold. Engine starts fine but runs rough at idle and the exhaust note sounds like passing gas,(farting) not a true backfire but an odd poping sound. Before I pull things apart I'm looking for...

I am replacing the cork seal at the end of the steering gear and I need to know what order the parts go on. In particular the concave metal washer. Does it go on first with the concave in followed by the cork washer, then the gasget, then the metal plate, then the metal end housing with no...

I need the length of the fuel pump push rod for the early 32 fuel pump. I'll try to post a picture but if not able it's the one that sits straight above the rod and not off to the side. V8 motor.

This is a freshly rebuilt 1932 v8 that I am trying to start for the first time. I have the engine turning by hand and by the starter but have no spark. The distributor is from Bubba's and included the coil and condenser. It is the helmet type. I installed it on the block with the...

Trying to start a rebuilt tight motor. Can I use a 12 volt battery on the starter only to get better turn without hurting the starter? Will a 12 volt turn the engine faster? thanks

What should the red wire to the coil/condenser read with the switch on? Thanks this is a 32 v8.

Trying to reconvert b gas pedal back to v8. Can anyone show or tell me what type of fitting was under the small cover at the gas pedal? The b had two eye bolts housing the pedal rod but the v8 has only one in the middle of firewall. Seems like there should a second or was the cover used to...

I'm trying to value a good running b motor with all components and transmission. I have posted a picture under 4 cylinder b motor. A value range would be helpful.

Removed my shifter lever from b motor#5232934 with shifter top #b7222 and when I put it back on it will not shift correctly. The 2nd and3rd speed work 1st and reverse stall engine. Lever seems loose and not engaging properly engaged. Any suggestions? Thanks