Search results

Getting ready to put a new motor in. I also have the transmission out from rebuilding it. Question I have is it a good or bad idea to install the motor and transmission together? I have never attempted this, your thoughts.

Looking for detailed information for hot and cold pressures and at what RPM's. Also is Bill still in business, I see the web site does not work.

Does anyone know if Berg's expertise in building quality radiators was passed onto to another supplier? Please suggest other recommended vendors. Quality as in Gery's is more important than cost. We all know the price of goods are up. Looking forward to your comments.

Looking to purchase a new rear "A" Spring. Is Travis Cook still taking orders?

Need to remove the steering wheel, to remove column from truck. Found that the column box will not fit up through floor. Any suggestions.

Looking to purchase a good BLOCK or or complete motor with no cracks.

Working on installing the lens rings. Purchased new ones and cannot get the latch to go over the retainers. I compared them to an original, the only difference I can find is the length of the latch bracket. I found that the original is approximate .100 longer than the new ones. The original...

I'm looking for a 4 Spoke Steering wheel and a Battery Tray. I think the correct part # for tray is 51-5151. I'm not working on a show truck, so looking for a usable wheel. I can repair a tray if needed. Tom Smith

Looking for contacts to locate a Battery Tray that mounts in the corner of frame and cross member under floor board.

Looking for a usable battery box, or one that could be repaired. If anyone has pictures of one, that would be helpful also.

Working on a Panel Delivery that has a On/Off switch, Not a Pop Out type. The keys are Briggs & Stratton #C399 Round Head. Was this used as a replacement switch? Is this type acceptable for Touring Class Judging?

Is there a correct orientation of the flat for mounting purposes? Working on installing a new set of floor boards in a 31 Panel Delivery Tom

Should there be some type of rubber floor mat used under the seats. Raised wood area behind the normal floor mat used. Any suggestions?

I have installed a new Rear Brake Roller Kit on my Backing Plates. I have made sure the shaft rotates good in the bushings. When I have assembled the shaft in the housing with the dust ring and lever with pin, it puts a bind on the shaft. I this normal? Or should provisions be made so ring does...

Just purchased a Ammco Shoe Grinder. Would like to make the holding fixture plates that I have seen pictures of. Anyone with a sketch or information they are willing to pass on.

I have the locking nut removed, but I'm not able to get gauge out from hole. Hole seems to small.

First to let all know that I have not worked on this vintage of brakes until now. I was asked to replace the rear wheel cylinders since I had the drums off checking the condition of the shoes. The front cylinders were replaced before, the rears were not. I replaced them with new that I was...

I'm working on a Model A that was converted over to Hyd. Brakes. I have never worked on them till now. I found that the shoes were reversed when installed, now I need to understand how to center them, and make proper adjustments. Shoe to drum fit needs improvement also.