Search results

When timing with test light is one notch enough advance timing or should light come on at second notch. Thanks Dana

When using test light to time engine is one notch enough advance timing are should timing be advanced for two notches. Thanks Dana

My horn sounds as good as any i have heard while parked but when driving it does not sound that good, any solutions. Thanks Dana

Does any of the suppliers sale a ball valve for under tank shut off instead of the tapered 1/4 mpt x 3/8 flared valve. Thanks Dana

My 31 coupe has always dripped a little, just noticed last couple weeks no drips after oil change, filler cap has been pushed down to far is only thing i can think of any other opinions. Thanks Dana

My: Coil is marked + & - which side does red switch wire connect to? Thanks Dana

Replaced TT10 with W18, went for four mile drive had some radiator over flow, haven't been having this problem, number four plug had some discolor on out side of plug, TT10 were some sooting up. any idea? Thanks Dana

Pack up set of Champion W18 plugs, will plug connectors work with them look a lot taller than TT10 I have in my 31 coupe now Thanks Dana

Does any one have a picture of the correct order in witch gaskets face plate and glass go in model a gas gauge also how many brass rings go under large nut. Thanks

Information on wiper vacuum hose routing for 31 coupe, mine runs out from under windshield frame and window will not stay shut. Thanks Dana

While under full throttle my amp meter drops to two amps, backing off throttle some it well increase to eight amps. weak brush springs are what? Thanks Dana

My 31 Coupe cranks and idles good, Power good but can not tell any difference past five notches on spark advance. Is this normal. When lever is up against distributor slot and down against slot. Thanks Dana

Guys, Noticed tires wearing today, aligned front end and could not believe how much better coupe drove. It was way out of alignment. Will rotate tires tomorrow. Thanks Dana

Does windshield hinge need lubing and if with what. Thanks Dana

What was the last 31 coupe serial number. I am out 4,477,9??. Just foundering how many more were made. Thanks Dana

What were the differences in 1931 deluxe and standard coupe. Thanks Dana

What is split sleeve rubbing are is it the key. Installed new two piece crankshaft pulley. Was careful to line up key with notch in two piece pulley. Once key in place pulled pulley on with ratchet nut, generator/water pump and crank pulley lined up good. Cranked up and loud rubbing sound and...

I think groove was machined in sleeve. Thinking of building clamp are drilling two holes and taping to install bolts for pulley puller. Does any one make pulley like this now days. any input. Thanks Dana

I need some more good Barn experience, made special tool worked like a charm to remove ratchet nut, pulley was about to give up. How does the piece with notches in it come off of the crank. Is there a key way. Some one in the past has had a pipe wrench on it. I can cut it off with torch but...

Barners I have had a click in front of motor, think I have found it. Th crank shaft pulley has some play in it. Can I simply tighten it up and what size socket is it. Thanks Dana