Search results

  1. yngrodder

    Model A engine number question

    I have a 31 model a coupe and the engine has a 8 digit number on it, looking online it looks like it should only have 7 digits.. It has a mark before and after the number and It starts with an A then 8 numbers, When looking up the Vin do I just drop the last number off?
  2. yngrodder

    55 t bird ?

    Are these exhaust factory or aftermarket? I'm looking at this car but I have no knowledge of older birds, any thing that I need to look at on it?
  3. yngrodder

    1939 ford coupe side chrome

    I have a good set of trim for a 39 standard coupe, there is a complete set of left and right side trim I bought this for a friend who ended up not needing them has side panels,cowl,door,rear quarter
  4. yngrodder

    1950 mercury pressure plate ?

    I ordered a 50 merc pressure plate from my local clutch store, I'm thinking I ended up with the wrong one but I'm unsure Its a 10 inch borg and beck but the bolt holes are 10 5/8 and the flywheel is 11 5/8 . so my question is do I have the wrong pressure plate or flywheel?
  5. yngrodder

    1941 Ford coupe

    Up for sale is a real nice 41 ford coupe. I bought it with intentions of chopping it and building a custom. I decided I would offer it up for sale or trade first...the car is very clean and was redone in 94 and was not licensed since until i bought it last year. It has a stock drive line with...
  6. yngrodder

    What fails in a 38 ford headlight switch

    I just bought a 38 ford and trying to learn the ropes on things, My lightse quit working and I took the cap off the switch and i am getting power to the switch and all the wires still look connected, so what on these fail? can the be fixed or do i need to replace the whole switch?
  7. yngrodder

    rear wishbone ?

    I bought a 38 ford coupe and there is a few strange things about it, and Im trying to figure out what is what? The rear wishbones has two sets of bones both start at the outside of the axle one runs to the center of the torque tube and the other runs to the end of the torque tube, They look...
  8. yngrodder

    1940 ford front and rear axle assemblies

    Like the title says complete front and rear suspension unbolted from frame has brakes,spindles,springs,axles,torque tube
  9. yngrodder

    41 ford flathead coil?

    Im having a problem with my coil to dist, the engine loses fire and dies, I have to loosen the coil and move it around a little tighten it back up and then it starts and runs with no problem again. It did it with the stock coil a couple times and I changed it to 12 volts and used a coil adapter...
  10. yngrodder

    lighting wire circut breaker

    I have a 41 ford and tonight about 150 miles from home the lights start going off and on and we smell somthing hot.. we narrowed it down to the box under the dash and we un did the wires and wired them together to get to our hotel room, what is this going to hurt to continue the weekend like...
  11. yngrodder

    1931 ford sedan for sale or trade

    I have a model a sedan two door chopped 4 inchs full fendered would like to trade for a 41-48 ford coupe, 49-54 ford two door, same year mercs. 53-54 chevy. Must be a 2 door with a back seat. First pic would be a 41 coupe. Follow link below
  12. yngrodder

    wanted to trade for 32 ford rails

    I have a real nice model A frame and a 35-40 frame that I would like to do some trading for a set of 32 rails,
  13. yngrodder

    1940 ford 2 door sedan

    1940 ford 2 door sedan LOWER PRICE!! 1940 Ford 2 door sedan project, Chassis is all stock Flathead with 3 speed trans Org Hyd brakes, Flathead turns over but does not have dist, carb and fuel pump will need these to make engine run, Body has been blasted and the main body has been put in primer...
Back
Top