Search results

  1. O

    pump

    On my 1956 Mercury Convertible I have arm strong steering & the belt is tight the power steering fliud is full any suggestions weather it is a malfunction of the pump or control valve or the ram??or other? Thank you in advance for input. Old Gas
  2. O

    Alternator

    Can anyone shed light on where I can purchase an alternator bracket kit for my 292 Y-block engine & what alternator to use. Thank you for your time in advance Oldgas:
  3. O

    steady rest

    Did Ford discontinue the front steady rest on the 1956 Ford Fairlane line-up late in the year of 1956? If Ford did this can i assume the steady rest is not essential at a motor mount & would be safe to not install it? Thank you for your time in advance. Old Gas
  4. O

    slinger

    Can you tell me how essential or important the oil slinger on the crankshaft I am understanding it keeps the oil away from the crank seal. Would I be correct in saying that? The slinger was missed on a re-build. Thank you in advance for your input. Oldgas.
  5. O

    Fuel

    I have purchased a fuel sending unit from Dennis Carpenter for my 1956 Ford Sunliner .Part No. .B6A-9275 Could anyone tell me the Ohm readings on full & on empty. Carpenter also indicates that this unit only is compatible with an original gauge which my gauge is original. Thank you in advance...
  6. O

    speedo gear

    I have installed a T10 re-built from a 64 Ford Galaxy four speed transmission in my 56 Ford Sunliner and wondering what speedo gear will work? Thank you in advance for any advise. Old Gas.
  7. O

    Lifters

    Looking for a good supplier for a set of 16 lifters for my 292 Y-Block Thank you in advance. Oldgas.
  8. O

    power steering pump

    Looking for the torque specs on the large 1inch bolt which holds the oil reservoir canister to the power steering pump housing on my 1956 Ford Fairlane. I have looked in the 1956 manual but no luck. Thank you for your time. Oldgas.
  9. O

    idler arm

    Looking for the Torx specs on a greaseable 1956 Ford Fairlane Convertible Idler arm. Thank you for your time. Oldgas
  10. O

    Drainage

    I have installed new inner rear Quarter trunk drop-offs, There is two rubber plugs to be installed in the drop-offs one is a vent & the other is a plug & the location to my understanding is at the front & rear of the drop-off question which on goes were? Thank you for your time. oldgas
  11. O

    Garnish

    Wanted the R/H A pillar interior garnish molding for a 1956 Ford Convertible also a 1955 Ford Conv or a 1955/56 Mercury Convertible mold will also work. thank you for your time. Old Gas ( Ron)
  12. O

    Fuel

    My 1956 Ford Convertible that has a fuel problem. Is there information on a blocked fuel pick-up tube on how to repair? Thank you for your time. Old Gas
  13. O

    Garnish

    Looking for interior dash/windshield garnish for a 1956 2DR/HT or Convertible there is 8 pcs. Thank you for your time. Oldgas:
  14. O

    seat springs

    I am re- building my rear seat springs in my 1956 Sunliner Convertible & have a number of springs that are broken & I was wondering where to purchase new springs? Can you help? Thank you for your time. Oldgas:
  15. O

    Seal Kit

    Can you tell me were to purchase new Control Valve seals for a 1956 Ford Fairlane P.S. set-up. Thank you for your time. Oldgas.
  16. O

    Inner fenders

    Question: Can you tell me if 1956 Mercury Montclair Convertible Inner Fenders will exchange to a 1956 Ford Fairlane Convertible & use the 1956 Ford Fairlane Convertible fenders? Thank you for your time. Oldgas ( Ron)
  17. O

    Inner fenders

    Question: Will 1956 Mercury Montclair Convertible inner fenders interchange to a 1956 Fairlane Convertible & then use the 1956 Fairlane fenders? Thank you for your time. Oldgas.
  18. O

    Muffler

    I have a 1957 Ford Convertible 312 engine & I need a pair of mufflers. I looked up the Ford part number being B7A- 5230 Left & Right & the spec's are 24" Length 2" inlet & outlet 4" in thickness & 7 3/4" in width but can not find a supplier can any of the members point me in the right direction...
  19. O

    seal

    Can anyone shed light on the manufactures name & part number for a rear pinion seal for my 1956 Ford Victoria my rear diff has 322 gear ratio if that means anything? Thank you for your time. Cheers Oldgas
  20. O

    Gear Ratio

    What did the 1956 Ford Victoria with a ford automatic transmission & a 292 2 barrel T pot Y-block have installed for best mileage performance rear diff gear ratio? Thank you for your time. Oldgas
Back
Top