Search results

I’m looking for a good operating Heinze wiper. Thanks, David

Does anyone know where i can get a B dist rebuilt? I don't think Renners is doing it anymore.. thanks dave

I have a B distributor and would appreciate some help in wiring it up. There is all kinds of information on timing but can’t find a picture of where the ignition switch wire goes. Thanks

Wanted Model B timing cover I found one thanks

When I put the car away last fall I noticed some small star shaped rock chips on the front fenders. I live on a mile and a half of gravel road and the tires are picking up rocks and causing the problem.. Does anybody use bed liner or ? under the fenders to stop this... would like to do something...

I have read Les Andrews book and other articles on removing the rear spring.. For you that have done this how high do you have to lift the frame to remove the spring? Don’t know if I should take this on or not but can borrow the spring spreader so ?

Looking for a 1933-34 front axle. Straight for use as is. Thanks Found one

I’m going to wire my model A to power trailer lights. I’m not a wiring expert so is there anything I need to be aware of? Thanks, Dave

I had a T5 put in. AA clutch housing. When I push in the clutch it will not come all the way back. I have to use foot to do so.. It has the required 3/4 to 1 inch free play just will not come back on its own. It seems to release and drove it in and out of garage ok a couple times. It does not...

I had someone put in the Randy Gross steering box. Now the spark advance lever only goes fully retarded and only half way to advanced..I read somewhere that it can be adjusted but can't find it...Anyone know how to do this? thank, david

I have to replace the steering box on my 30 coupe. I've done the adjustments, and the rest of the steering system seems good. Smith and Jones has a rebuilt steering column and 2 tooth box that is ready to install. Has anyone used this? Am thinking of the F100 also. Thanks, David

I just received a set of Stipes shocks and there are no instructions as to their use. Does anyone have a set of instructions or aren't there any? I emailed them but no reply. I'd like to get them on this weekend. Thanks, David

1930 coupe came with sealed beam headlights. would like to change to quartz halogens. what would i need to do to make the change?.i'm going to change to a 6 volt alternator. Thanks, David

I would like to add a volt gauge to a 1930 coupe. I am going to keep the amp meter. It's a 6 volt positive ground alternator system. Does anyone know of a good gauge and a wiring diagram? Thanks, David

Going to install a disconnect switch in my 30 coupe. The previous owner moved the battery to the engine firewall. I'm thinking of mounting it either to the starter with the mount you can buy or the firewall and control it from inside. Question is, should I get a 2 pole, which I would hook up to...

I ordered a replacement front spring shackle and one side is a little longer than the other. Is this right? If so which goes where?

Anybody use this stuff. Always try to use non ethanol but not always possible.

Trying to grease spring shackles. I have 2 that won't take grease. Took the fitting out and grease goes through. Is there a way to clean out the shackle so it will accept grease? I have a can of blaster standing by. Thanks, David

I have heard this referenced several times. What benefit and what is a V8 clutch? Thanks, just new at this and trying to catch up.

New owner of a 1930 coupe. I have been trying to figure out the junction box wiring but have not been able to find a picture of one that is open. Mine did not have a cover on it so wires are visible. Would like to put it back right. Tried to enclose picture of mine Thanks, David