Search results

No longer available

Looking for some used TT rear springs and hardware. Thanks, Pat

Looking for info on this King engine tester MT-830. Would like a base cabinet and user manual, any help would be appreciated. Thanks, Pat

Looking for Main bearings with good babbitt. Early or late style. They are for a cheap, used parts, engine rebuild I'm trying. Thanks, Pat

Safe travels to all Ford A-AA folks out there today. Enjoy what America has to offer, because of the sacrifices made by Americans before us. Pat

I've removed clam shell holding brake shafts and foot linkage rods. The cross member to the rear of the under drive has another clam shell and plate. Question is what do I have to do to get the under drive out to change seals ? I have been Googling like mad, but can't seem to come up with an...

Body number TC709. I know the TC stands for Twin Cities Plant. Any help on the 709 would be greatly appreciated. Pat

Wanted to buy early 28 AA front and rear fenders. Must be in good shape and will pay dearly. I also have 28/29 A CCPU parts I would trade. Cabs, frames, and a very nice narrow box. Thanks, Pat

Frame is pretty straight now. I have about a 1/4" bow in the upward direction from rear motor mounts to both horns. Will the body and engine weight take enough away from that 1/4" so I don't have problems elsewhere ? Also, some of the cast brackets were drill out to a egg shape. What would be...

sold

Yesterday I tore into my first Model A motor:cool: I thought the motor was junk for years, so I figured I'd wreck this motor learning what not to do on the next one. Well to my surprise after removing the head, valves, and pan I find the motor was rebuilt at some point .010 over. Crank spins...

Last motor Lincoln Johnson built. Firm on the price, don't need to sell. Bought to put in my truck and then found out I have the original motor in my truck. So time to get that running instead. Engine has no carb, starter, or generator. What you see is what you get. Local pickup only. Thanks...

Key fits tight in keyway, but I'm a little concerned about the chipping. I would like to at least put new seals in the axle housings and check other components out while I'm in there. Question is, is the axle chipping excessive enough to warrant the need for a good replacement ?

The man (Hine), who lived on the farm before me, built this large riveter. I would like to know if this is for doing brake linings. Would the small riveter also work ? Drill press is just something else he built. Thanks Pat

What are the chances of running a 32 volt DC 6 amp fan off a 6 volt system? It's a desk top style with variable speed and a 10" diameter fan.

Frame differences I have read. This took me back some !! Need to get it going and I need to start right. Don't need anything but stock or good repo items on my A. Frame is a good place too start :( Any good sites where pictures are incorporated with the upgrades on the frame ?

Model A frame Pre-Nov 28. Needs to be in good condition. Thanks Pat

I've been told that I should use copper gaskets on the water inlet/outlet, manifolds, carb to manifold, and head. Where can I buy a set of copper gaskets or buy them separately ? I've looked in "my" normal places and can't seem to find the copper carb and water inlet/outlet gaskets. I found...

Looking for new repo or good used lower cowl post brackets. Attached photos. Any help would be appreciated. Thank You Pat

A few pictures of my stuff !! Want more, lots more !!