Search results

Anyone know the thread size on early ford tie rods? I thought they were 11/16 X 18. Some are saying 11/16 X 24? Never run into a 24?? Thanks

looking for a place to buy 3/4 ton ford taper locks that go in the axle shaft of a full floating rear.......the are the split pyramid looking piece that helps center the axle......i need 16........thanks for checkin....j/m

Looking for a mercury pressure plate #10A7 for a core or a decent usable one. Lv message or call 978-356-4951. T/y. Jim

i wonder if anyone could post pictures of a 1946-48 ford clutch equalizer shaft i believe it has one end slotted at the bellhousing end and on the other end it is supported by a round ball and 2 half round bushings .....it also should have a small lever/arm off of the shaft too.....perhaps with...

need pressure plate from 1950 mercury......lv message etc....thanks