Search results

  1. john in illinois

    Mtfca

    What happened to MTFCA website. Seems to have vanished. John
  2. john in illinois

    Who makes F 150 T 170 transmission kits?

    Dave Delmue quit making them. I think there were a couple of others. John
  3. john in illinois

    Bubba’s ignition Mallory distributor

    Bubba’s ignition Mallory distributor ***SOLD*** SOLD I bought this before Jim Linder quit making them. I used it for about 5 Minutes in a test engine. It comes with 2 sets of wires resistor and plain wire and the drive shaft. It is in new condition. $300 plus $10 shipping John
  4. john in illinois

    Porter Mufflers

    Porter Mufflers ***SOLD*** *****SOLD***** John
  5. john in illinois

    interesting auction including 2 ARDUN V8 60's

    http://www.vanderbrinkauctions.com/catalog/?auction=4709 John
  6. john in illinois

    40-41 crankshaft pulley

    91-A-6312-A single pulley with fan mount. Pulley is not bent and seal surface is good. $50 plus $13 shipping. Has pipe wrench marks as shown. John
  7. john in illinois

    Driving in the rain

    I have not got the top hood on my roadster yet. The crab distributor has a gasket under the cap. Would the ignition drown out in a light rain? Any other problems. Thanks,John
  8. john in illinois

    Skip Haney center bearing kit. ***SOLD***

    Center torque tube replacement bearing kit consisting of bearing and sleave,locating tool, and instructions. NIB $100 plus $10 shipping. ***SOLD*** John
  9. john in illinois

    pistons for a 21 stud

    Are pistons for a 36 available in a larger oversize than .060? John
  10. john in illinois

    Facet electric fuel pumps ***SOLD***

    Two Facet 40-163 fuel pumps 1 1/2- 2 1/2 psi. One used for 1k miles and works fine other is NIB. $50 for both plus $13 shipping. John
  11. john in illinois

    40 truck column drop

    40 truck column drop ***SOLD*** Complete and every thing works. Key extends steering lock and switch works. $100 plus 13 shipping. John
  12. john in illinois

    2” polished carb risers ***SOLD***

    2” polished carb risers ***SOLD*** Risers plus studs. Cost $80 unpolished. Sell for $40 plus $13 shipping. SOLD
  13. john in illinois

    Balancing 40 Ford tire

    Can you balance a tire on a genuine 40 Ford wheel by indexing off the center hole? I know 35 wheels need lug centric balance. John
  14. john in illinois

    Like new Offenhouser reg. dual manifold

    Like new Offenhouser reg. dual manifold **SOLD** Nice manifold,very little use. $195 plus shipping. 2” risers $40 Will sell separately. John
  15. john in illinois

    Any one using new Auburn tires.

    I am considering buying 4 Diamond Back Auburn 600-16 tires. I would be replacing worn Coker classic radials. I like the Cokers but I would prefer tubeless tires. I do not wish to run Cokers tubeless. Any input is appreciated. John
  16. john in illinois

    flow direction in slingshot manifold

    In an Edelbrock slingshot does the rear carburetor feed the front cylinders. John
  17. john in illinois

    Gas leaking from float bowl

    I have a 97 that leaks internally from float bowl. It is not evaporating,and with the air horn off I can watch it drop. Fuel level seems correct. I have had different power valves in it,so I do not think it is pv leaking. Could the accelerator pump check valve be the cause? It pumps ok and the...
  18. john in illinois

    Brake comparison Bendix vs Lockheed

    Our Model A club had a tour to a brake test lane and the owner let us test our brakes free. The machine had 1 vertical tube for each wheel. Liquid rose in the tubes to indicate brake force. He had it set for light cars. We drove on at approximately 5mph. My Tudor has MT Lincoln Bendix brakes...
  19. john in illinois

    Swap 97s to 94s

    What is involved changing carbs as far as linkage and fuel lines? John
  20. john in illinois

    Resitor plugs

    I can get NGK plugs either resistor or non. Is there any performance reason to use one or the other? John
Back
Top